I have a 2002 silverado the abs and brake light stays on any ideas?
You could have two separate issues or just one. First check the level of brake fluid. (brake light)Fill it and if the light goes out, then you have to use a CReader or scanner to get the ABS codes. Cold be wheel sensors, broken wire, or the ABS module. If you can't get the brake light to go out, then it is the ABS, three possible causes. One is the ABS module is dead. second is the pump has failed. third is a bad ground wire. check the ground first. The ground is the biggest wire going from the pump /module to the body. When these loose ground, I cut the end off and run a longer wire to a better spot on the body. When you see it, you will know why.
Testimonial: "that was very helpful thanx"
Randy nailed it! See above...
Could be a ECBM. Mine has been like that for a while. Pretty expensive to replace, but there places online that can repair pretty cheap
More likely a faulty brake light switch
Take it to a dealeship and have it scanned for a ABS fault, it will pin point what wheel sensor/bearing assembly is bad
One of your abs sensores is out or unpluged,, there are 4 on your vehical,,, one on each tire
1,944 views
Usually answered in minutes!
×