Question about 1998 Mitsubishi Montero

1 Answer

My left signal on my Montero 98 it stopped working like 2 days ago I change that flashing fuse but still the same the only thing I hear it weird noise inside the fuse but my right signal is working

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Mitsubishi Master
  • 531 Answers

The bulb is ok? visual check? switch the left and right side bulbs if they're easy to get to

hazard light swich on should flash both sides as well... is it doing that?

grounding issue on the left. gotta trace the ground wires of the left side and make sure the grounds are not corroded when bolted to the body of the vehicle

Posted on Apr 01, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

motor1258
  • 6674 Answers

SOURCE: LEFT TRAILER TURN SIGNAL DOES NOT WORK

I'd get a 12vdc test light if you don't have one already & start from plug, and keep probing back from there. It may be as simple as a bad connection under truck where joined into harness.

Posted on Nov 29, 2008

  • 196 Answers

SOURCE: electrical problem

Find the ground wire on one of the lights and add another ground wire to a good clean metal surface and see if that fixes the problem. It defently sounds like a ground problem at one of the lights.

Posted on Jan 07, 2009

  • 12 Answers

SOURCE: Turn signals dont work 97 Geo Metro

I had that problem on a 90 Metro. I found a plug located on the top side of of the fuse pannel under the dash came unpluged.

Posted on May 10, 2009

  • 7 Answers

SOURCE: Turn signal lights stop working. Neither the right or left turn signal work. Heard a noise before it stop working. The flashing started slowing down and stop blinking. Now it doesn't work at all. What

most likely its the turn signal relay. which is under the hood. in the fuse box. also make sure ur running lights are working if they are connected to the turn signal.

Posted on Jul 23, 2009

  • 5 Answers

SOURCE: Rear right turn signal does not work.

check the front right bulb

Posted on Sep 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Left turn signal doesn't flash.


there is a flasher under the dash put your 4 ways on and listen for the tick noise find the flasher unit under dash area driver side there is two one for the 4 ways and 1 for turn signals now that you have found them turn on working signal touch the flasher unit you will feel it pulse and hear the noise when you have the one pulseing on working signal this will need replacing can also be in fuse area have a good day

Nov 22, 2014 | 1990 Buick LeSabre

1 Answer

98 honda has grinding noise only in park and neutral stops when put in gear


where do i change my fuse or light volve in honda accord 1999 signal light don't work

Jan 05, 2013 | 1998 Honda Accord

1 Answer

I have a 90 montero and the brake lights and turn signals stopped working and I have replaced the fuses and can't figure it out.


my 91 Montero did the same thing, I finally traced it to a bad rocker switch for hazard lights. The switch was broken and it messed up brakes and turn signals. Check your switches that they work and rock properly. My hazard switch was binding turning on and off causing a short. Got a new hazard switch that worked freely and suddenly everything worked right. The problem drove me crazy, and I did replace the turn signal lever assembly first, brake switch, turn signal relay. I found dash switches on eBay.

May 22, 2012 | 1990 Mitsubishi Montero

1 Answer

I have a 2000 Dodge Durango and we have been having blinker problems too lately. Sometimes they worked, sometimes they didnt, and the other day they went out completely.They have been doing this for a...


that vehicle has a desperate relay for the hazards which is why they work, you have a defective signal flasher sometimes called a signal relay, follow the noise to locate exactly where the part is, usually under driver side of dash, it is a very cheap part and easy to install.

Sep 26, 2011 | 2000 Dodge Durango

2 Answers

Turn signals aren't working but flashers are


that is because they run off different systems, they both have thier own relays, normally the common fault with flashers not working is either, fuse, or relay (flasher repeter unit), if you turn your turn signals left or right can you hear a click click click noise? if not its your flasher unit, hope this helps

Feb 01, 2010 | 1994 Chevrolet S-10 Blazer

1 Answer

Mitsubishi montero sport signal light malfunction


I had the exact same thing happen to my '98 Montero Sport.... the entire lever assembly most likely needs replaced because a switch inside of it broke. That is if it's the same as mine was which it sounds exactly like it is. I had to get the part from Mitsubishi and it cost somewhere around $100. You get a whole new lever assembly and mine is working great now, feels a whole lot better than it has in years. In the meantime you can take out the turn signal fuse in the interior fusebox to stop the turn signals entirely until you can fix the problem. Good Luck! corymaier@gmail.com

Sep 04, 2009 | 1998 Mitsubishi Montero Sport

2 Answers

98 Sebring JXI turn signals work right/left and


Change the flasher which is located up by fuse block under dash

Jul 29, 2009 | Chrysler Sebring Cars & Trucks

1 Answer

Turn signal lights stop working. Neither the right or left turn signal work. Heard a noise before it stop working. The flashing started slowing down and stop blinking. Now it doesn't work at all. What


most likely its the turn signal relay. which is under the hood. in the fuse box. also make sure ur running lights are working if they are connected to the turn signal.

May 08, 2009 | 1993 Nissan Pathfinder

1 Answer

98 Hyundai Elantra turn signal and hazards only work sometimes.


You need to replace the fuse - have a look at the manual and see which fuse it is buy a new one put it in and it should be fine - the on off thing is where the fuse wire touches and then moves again.

Dec 29, 2008 | Hyundai Motor 1993 Excel

Not finding what you are looking for?
Cars & Trucks Logo

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...