Question about 2013 Nissan Altima

1 Answer

My 2013 nissan altima gas gage is at the f line and it wont move ive driven for 98 miles and itt hasnt moved yet..please help

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 50 Answers

Check your gauge in side the tank. It somtimes stick on one position. Need to replace.

Posted on Apr 01, 2015

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why doesn't my 2013 Nissan Sentra recognize the FOB? Says FOB "not detected" when its in my hand. Is this a dead battery in the FOB? how do I get this fixed?


Does the key fob open the and close the door? If it does the battery is fine.

This seems to be a known problem. Move the fob closer to the Start Button.

http://www.nissanclub.com/forums/2013-nissan-altima-discussion-2-5-3-5/337333-intelligent-key-not-recognized.html

Instructions for reprogramming

http://www.nissanhelp.com/diy/common/nissan_reprogram_key_fob.php

http://www.carcomplaints.com/Nissan/Altima/2014/electrical/fob_not_recognized.shtml

Dec 02, 2015 | 2013 Nissan Sentra

1 Answer

Nissan Altima shifter moves but car won't move in any gear


are you shore its going into gear and not just moving the gear stick you will need to check this first. if its just moving and lose its come off its shifter and you will need to jack up the side of the care to get to it to put it back on . the locking bolt may need to be replaced as they have been known to fall out...

Mar 24, 2014 | Nissan Altima Cars & Trucks

1 Answer

Hi. I have a 99 nissan altima. My problem is with it dying in gear. Forward or reverse. It runs a little rough at idle (about 500 r.p.m) you can rev it up to 3-4000 no problem, as long as it is in neutral...


Check the throttle positioning sensor and the transmission, it sound loke the sensor is givving bad information to the computer whis is cutting the engine when in gear, this might cause the transmission to break its syncro plate if it slamms in and out of gear.

Jun 30, 2011 | 2003 Nissan Altima

1 Answer

I have a 2008 Nissan Altima and when i press the furl relase in the car the gas dooro wont open. Any suggestions please??


Pull the emergency cable in the trunk on that side to open the gas door and then heavily spray WD40 into the pin latch that holds the gas door closed.Work it back and forth by pushing it in and out with finger until moving freely

Jan 20, 2011 | 2008 Nissan Altima

1 Answer

06 Nissan Altima wont shist out of park until it warms up.


Check the fluid level. It sounds as if it's low.....:-)

Feb 22, 2010 | 2006 Nissan Altima

1 Answer

I have Nissan Altima with incorrect guage reading


The Correct Rerpair for this to to REPLACE the FUEL LEVEL Sending UNIT. It is Located INSIDE the Fuel Tank, After Reserching this through Numerous Resources I Have Fould that it is Incorperated into the FUEL PUMP. So You can Use your Current Calibration Method or Replace Fuel PUMP. Looking at the Vehicle AGE and IF IT HAS OVER 100K Miles on it , It is Advisable for you to Replace the INTIRE UNIT. It is OBVIOUSLY Not Manditory as the Vehicle is RUNNING, But If you Wish to Have Accurate FUEL LEVEL Reading Replacment is the ONLY OPTION.

Sep 01, 2009 | 1997 Nissan.5 Altima

1 Answer

Nissan 1999 Altima won't go into gear properly


howdy,you need a clutch..thats for sure,101%

Jun 05, 2009 | 1999 Nissan Altima

1 Answer

Wipers wont work


check bolt or nut under connection at arm to motor , if it is press on check that connectors from motor to wipers is not broken .

Jan 06, 2009 | 1998 Nissan Altima

1 Answer

2006 Nissan Altima Gas gage and AC not working


clutch not engaging 2005 Honda Odyssey
You test A/C systems all makes the same !
Could have a bad fuel level sending unit , inside the fuel tank ! video's on youtube on how to test !
Fuel Gauge Tech How To Properly Diagnose Faulty Fuel Pump Sending Unit

Jun 03, 2017 | 2006 Nissan Altima

Not finding what you are looking for?
2013 Nissan Altima Logo

Related Topics:

106 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...