Question about 2004 Nissan Titan

1 Answer

Is replacing the Body Control Module on a 2004 Nissan Titan as easy as removing the old one and plugging in the new one?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Welcome Back:

    Visited the website for 2 consecutive days.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

The answer to your question is no, The BMC controlled directly by the BMC are.
1. Power door lock system
2. Remote keyless entry system
3. Power window system
4. Sunroof
5. Interior room lamp
6. Warning chime
7. Turn signal and hazard warning lamps
Configuration EKS00777
DESCRIPTION
U1000
CONFIGURATION has two functions as follows:
? READ CONFIGURATION is the function to confirm vehicle configuration of current BCM.
? WRITE CONFIGURATION is the function to write vehicle configuration on BCM.
CAUTION:
? When replacing BCM, you must perform WRITE CONFIGURATION with CONSULT-II.
? Complete the procedure of WRITE CONFIGURATION in order.
? If you set incorrect WRITE CONFIGURATION, incidents will occur.
? Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
READ CONFIGURATION PROCEDURE
CAUTION:
If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be
detected in self-diagnosis depending on control unit which carries out CAN communication.

This came right out of the 2004 titan manual don't think it's the answer you wanted to hear.

Posted on Mar 31, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 30 Answers

SOURCE: replace control panel on 2004 nissan quest

there is a c-clip you need a small screwdriver to pull it out then gearshift knob will pull off

Posted on Jan 28, 2009

  • 51 Answers

SOURCE: 2004 Nissan would not start

Try checking your battery and or starter. If not them you might have another electrical problem.

Posted on Apr 29, 2009

relaga58
  • 158 Answers

SOURCE: 1997 nissan altima has no spark at the plugs.

get those sensors connected to the output of the module tested cause its ruining the module

Posted on May 10, 2009

emissionwiz
  • 74945 Answers

SOURCE: code p0455 evap emission (large)

have the gas cap tested or just replace it, then disconnect the battery for 5 minutes to reset the code, then drive it for a few miles and see if problem comes back, if it does a trip to the dealer is in order, as this may be covered by your emission warranty which is good for 70,000 miles.

Posted on May 26, 2009

messstat
  • 365 Answers

SOURCE: how do i remove the inside panel of a nissan titan door

Get a 18V drill with phillips screw extention and start buzzing the screws in the armrest and under out...the glass could be anywhere so wear gloves.
Good Luck

Posted on Jun 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Blower motor not working in my 2004 Nissan Titan. Can someone tell me where I can find the fuse for this and for the blower control module so that I can check to see if that is the problem. Thank you.


Check owners manual for fuse block(s) location. Check fuses, then check for power at connector going into motor. May be ground controlled circuit, so you may need to check in reverse. If you have power there, and are able to change voltage with fan speed control, its your blower motor.

Nov 22, 2013 | 2004 Nissan Titan

1 Answer

No fire for 2004 nissan titan,replaced crank position sensor,throttle body(TPS sensor),spark plugs,fuel pump.


How about the high voltage coil, the high voltage wires to the distributor cap, the cap itself and the rotor inside. Any one of these could be the problem.

Jan 20, 2013 | 2004 Nissan Titan

1 Answer

Where is the TPS sensor located,2004 Nissan Titan 5.6 v-8


The 2004 nissan titan is drive by wire, meaning there is no cable to control the gas pedal to throttle.
This system is computer controlled with a motor at throttle body and pedal sensors.

the TPS throttle position sensor is located inside the throttlebody . on most of these the complete throttle body must be replaced as there is no sperate tps sensor it is complete,
i would check and make sure this is the problem . GM started making TPS replacement sensors for there throttle bodies.

Jan 06, 2013 | Cars & Trucks

1 Answer

U1000


U1000 - CAN Communication Line Signal Malfunction

Causes:
- Harness or connectors (CAN communication line is open or shorted)
- Faulty Engine Control Module (ECM)

Solutions:
- Poor harness ground connection

There is a service bulletin for the following Nissan models with U1000 code:

2002-2006 Nissan Maxima
2004-2006 Nissan Titan
2004-2006 Nissan Armada
2002-2006 Nissan Sentra
2005-2006 Nissan Frontier
2002-2006 Nissan Altima
2005-2006 Nissan Xterra
2005-2006 Nissan Pathfinder
2004-2006 Nissan Quest
2003-2006 Nissan 350Z
2003-2006 Nissan Murano

The service bulletin suggest cleaning engine and body harness ground connection to repair problem.

Feb 14, 2011 | Nissan Versa Cars & Trucks

1 Answer

2005 Titan: trying to replace 2006 nissan blower resistor...


It's under ther dash little squarish box., 2 screws and a white plug very easy to fix. i just did mine in my 05.

May 18, 2010 | 2005 Nissan Titan

2 Answers

My drivers side air bag deployed and the Nissan Service Manual indicates the Spiral Cable assembly must be replaced with the air bag module. Niether I nor my local dealer can locate any part called the...


What kind of dealer can not locate spiral cable?
The name of that spiral cable is CLOCK SPRING ,
it's under steering wheel , connecting air bag at wheel to main harness.
I would recommend to change the dealer before your air bag shoot you in the face.

May 05, 2010 | 2004 Nissan Titan

1 Answer

2004 titan


posible problem on ipdm module is the big fuse box toward the back on the right side inside engine compartment, some times the ecm relay goes out you might have the begining of this problem. (you canot get the relay by it self, only the whole module) I hope to be of help to you.

Aug 14, 2008 | 2004 Nissan Titan

Not finding what you are looking for?
2004 Nissan Titan Logo

188 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...