Question about 2011 Honda Odyssey Touring

Open Question

MID display not responding to strewing wheel controls? Not able to customize settings.

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What causes the speed to fluctuate when you set the cruise control?


if it just started to happen you may have lost a magnet off the drive shaft. If it is a front wheel drive then you would have two magnets on the flywheel if you lost one magnet it would cause problems.
The other possible cause if the sensitivity setting is set too sensitive then the cruise control will surge .
Setting it lower will allow it to slowly respond to speed changes but if going up hill it will take a while to increase the acceleration . Or going down hill it could accelerate too much before the cruise control realises it is going downhill
Also a very wet road can cause the wheels to spin and cause the cruise control to lose the plot and accelerate to dangerous speeds.
I have had this happen to myself once so be wary of cruise control use in wet conditions.

Jan 14, 2017 | 1992 Honda Accord

1 Answer

My radio knobs and display stopped working, but the stations can be changed with the steering wheel controls.


Hello Monica Briggs,

I've been into three different "wheel control" sound systems...

One for sure had a SEPARATE FUSE for the radio (FACE versus STEERING-WHEEL) controls...
(that was ... Find THE OPERATED FUSE & replace it).

Two was a SIMPLE RESEAT (unplug/re-plug) of the REMOVABLE face plate...

Three most interesting by far was a STUNNED radio...
Last operated from the steering wheel ... would respond to no inputs (any-source).

Thanks to Bill Gates (BLUE SCREEN of D**TH) training the WORLD on the POWER-RESTART ... We simply disconnected the CAR Battery for a minute... put it back together... set the time & stations.. and pretended we knew what we were doing...

Hope this is at least inspiring... Good luck.


If perchance your vehicle is a popular USA model... look
on the BBB Industries FREE Wiring Diagrams & Technical Service
Bulletins***... (registration required (but well worth it)).

Otherwise search your Model+WORKSHOP+REPAIR+MANUAL
to get your technical specs.

***Bulletins:
BBBind.com is where I found a clogged A/C drain was causing water damage to a HIGH-END Toyota sound system.


BBB Industries Premium Alternators Starters Power Steering Products

May 28, 2016 | Cars & Trucks

1 Answer

2005 Honda element ingition switch do you have to take strewing wheel off


No, you don't have to take the wheel off. Just have to take the cover off between the wheel and the dash. Once that's off, then you will have access to the ignition. The only thing is, when you get your new ignition in, you will have to take it to a Honda dealer and have the ignition and key coded together. It will save you some money to put it in yourself, but you will have to tow it wherever the closest dealer is for you.

Sep 13, 2014 | 2005 Honda Element

1 Answer

How you change horn pad at the strewing wheel


You remove the airbag first ,two screws/allen headed /torx headed screwqs on the back of the steering wheel ,this is a specialised job and dangerous so disconnect the battery first to stop the air bag from going off ,or better still take it to a mechanic

Aug 11, 2014 | 2006 Toyota Tacoma PreRunner

1 Answer

I have a clicking noise coming from the back of my vz strewing wheel after I installed my new clock spring


remove the wheel and recheck everything is in place and no trim,wires etc catching when steering turned

Jul 20, 2014 | Cars & Trucks

1 Answer

Hi, my 2.8 Diesel GWM display both the amber wrench and the check engine lights, it start normal but drive terrible in fourth gear, it sometimes wont respond or delay to respond to the accelerator pedal,...


The wrench means you need to service the engine ASAP. The check engine light has a lot to do with all the pollution control devices on the vehicle. It could be the fuel filter I always recommend to my customers to change them out on a diesel every 15,000 miles . It will save a lot of headaches.

Nov 24, 2013 | Cars & Trucks

1 Answer

My windsheild wiper motor sometimes stops mid way through the stroke and sometimes it doesn't work at all. If you leave on though it will eventually work but after a few minutes it starts to stop mid way...


It sounds like you have a faulty switch. I would recommend that you change the wiper control switch. In order to do this, yoyu will need to remove the steering column cover, and the steering wheel. Remember to disconnect the battery when you are performing any work in a car that has a SRS-safety restraint system.

Mar 21, 2011 | 2004 Pontiac Grand Am

1 Answer

I e bmw e46 with multi functionsteering wheel and i need to set service/oil can u helpi have been told i can do this on the steering wheel s that correct nd how please


A.
Model Year 1999 to Mid-2000: You should have the older round 20-pin DLC
connector under your hood behind the battery terminal, you need to use a small
length of wire to connect (short) pins 7 and 19 for 3-5 seconds with the
ignition key in position 1 (Accessory).

B. After Mid-2000: You should not have the 20-pin DLC connector.
You only need to hold the left odometer reset button while turning the key to
position 1 (Accessory). Keep holding the button for 5 or so seconds until any of
the following shows in the display: OIL SERVICE or INSPECTION with RESET or RE.
Release the button and press it again for another 5 or so seconds until RESET or
RE flash. While the display flashes, press the button one more time briefly. If
done correctly, END SIA should show up for a few seconds. All done.

Read
more: http://wiki.answers.com/Q/How_do_you_reset_the_oil_service_light_manually_on_a_2003_BMW_325i_E46#ixzz1A2pMDIif

Jan 03, 2011 | BMW 325 Cars & Trucks

1 Answer

What is function of trac on/off control? What is best setting?


Trac is short for Traction. In english and easy terms on older cars only one wheel was used for forward motion..on newer cars (mid 70's and later) they have dual traction whereas both rear or front wheels provide motion from engine. With even newer cars 1995 and forward many manufacturers began installing intelligent or positive traction. This means that the car can sense when one of those wheels is losing grip and transfer more of the engine output and torque to the other wheel. They did this so if one wheel was on an ice patch but the other wasnt it would still move, etc, etc. Your car, and many others, gives you a button to decide if you want the engine computer to monitor the wheels and automatically do this for you or if you want to turn off the monitoring and have the power to both wheels be the same. You should run with traction control on during normal operation. If you are in deep snow or other conditions you can turn it off to get more force out of wheels to get unstuck, etc.

Jun 05, 2010 | 2006 Dodge Grand Caravan

1 Answer

Can't get the DVD player to wok in my 2006 Lexus GS300


Repair Procedure
1. Confirm the customer's complaint of DVD RSE system inoperative.
2. For vehicles with Lexus Navigation System, perform the following procedure to turn OFF the RSE Lock function:
A. Press the INFO button to display the "Information" screen on the navigation unit.
B. Press the "Screen Setting" touch button on the navigation display.
C. Under the "Rear Lock" option, press the "OFF" touch button and then press "OK" in the upper right part of the display.
D. Press the DVD switch on the RSE system, (If a DVD is NOT already in the player, insert one) and confirm screen is "ON" and the system will play DVD's.
3. For vehicles without Lexus Navigation System, perform the procedure to turn "OFF" the RSE Lock function.
A. Push the audio control knob multiple times to cycle through the various options (Bass, Mid, Treble, etc.) until "Rear Lock" is shown on the screen.
B. Turn the audio control knob so the display says "OFF" next to "REAR LOCK".
C. Press the DVD switch on the RSE (if a DVD is NOT already in the player, insert one.) and confirm screen is "ON" and the system will play DVDs.
4. If the above procedure resolves the concern, explain the system operation to the customer. This procedure is described in the "Audio/Video" section of the vehicle owner's manual.let me know lf this helps.

Jun 14, 2009 | 2006 Lexus GS

Not finding what you are looking for?
2011 Honda Odyssey Touring Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...