Question about Ford F-150

1 Answer

I have a f150. There is a chirp in the engine compartment when the gas pedal is pushed. When the truck is running and rolling without gas, there is no chirp. What can be the cause?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 373 Answers

This is usually due to a loose fan belt. It may be time to change them.

Posted on Mar 31, 2015

  • K barch Mar 31, 2015

    Already checked ... Fan belts are good.

  • Bryan Smith Mar 31, 2015

    It may be a bearing that is getting dry, but usually that would continuously scream.

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 178 Answers

SOURCE: 1999 rodeo 6 cyl

hello from what you explained i take it theres no check engine lights on what it sounds like is a basic increase on your idle screw get somone to help push pedal down underhood look to see where gas cable pulls back when gas pedals appled have them release slowly now watch where it stops against a set screw that is your adjustment rpm range should be somewhere between 750-900 rpm depending on vehicle if this doesnt solve most likely tps sensor{ throttle position sensor} goodluck

Posted on Sep 13, 2008

  • 1 Answer

SOURCE: 1998 Dodge Ram 4X4 Pickup

Try disconnecting the battery (both terminals and let set for a few hours) with ALL the accessorries on lights-heater-radio etc. This will draw all power from your system, then recconnect battery, it's worth a try even if it doesn't solve your problem. Bill

Posted on Nov 09, 2008

  • 8 Answers

SOURCE: car won't start without gas peddle.

a dirty throttle can cause that

Posted on Nov 15, 2008

emissionwiz
  • 76630 Answers

SOURCE: 89 f150 wont fire

Check and see if u have spark to the plugs, if you don't replace the TFI ignition module on the distributor and the pickup inside the distributor, the dist must be removed to do this coil pickup replacement.

Posted on Mar 04, 2009

  • 14 Answers

SOURCE: push gas peddle and once i reach about half

check your TPS throtel position sensor. and the vehicle has a rev limiter so it wont over rev n park and nutral. but thats the first thing i would check do to many TPS's wear out and can get dead spots in them.

Posted on Aug 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why my car is not accelerating when i push down the gas pedal


This kind of cars the gas pedal is electronic, that means there is no metal cable to the carb. the first thing is check for any disconnected wire harness at the pedal or on the engine compartment at the throttle body everything looks fine the pedal could be defective

Nov 25, 2015 | 2005 Nissan Altima

1 Answer

Car will not accelerate when gas pushed


Clutch plate and pressure plate seem to be too weak to pull the car. To test the clutch plate, park the car on flat surface. Pull the hand brake up, start the car, depress the foot brake pedal, depress the clutch pedal, put the car in 1st gear, press the gas pedal and leave the clutch pedal at once, while keeping the brake pedal depressed.
Follow one of the two following statements:
1. Engine does not shut down and remain start. (Clutch plate, pressure plate and clutch bearing defective - Replace all as a set)
2. Engine shuts down. (Clutch system is OK and does not require any repair).

May 22, 2013 | Honda Civic Cars & Trucks

1 Answer

How can I bypass the starter in my car(manual trans) so it will start? I had the battery checked and it's fine.


  • If the engine cranks ("rrr-rrr-rrr") when you turn the key, then the problem isn't the starter or the battery.Plan to have at least one person sitting in the driver's seat and one or two persons pushing.Turn off all accessories (radio, wipers, lamps).Turn the key to the "on" position.Depress the clutch pedal with your foot.Put the transmission in first or second gear.Release the hand brake and the foot brake.Note that the people pushing need to get the car rolling as fast as they can. This works best down a hill or an incline.Release the clutch pedal while giving the engine a little gas with the gas pedal once the car is moving about as fast as you can run. The engine should start

  • Jan 12, 2011 | 2004 Acura TL

    1 Answer

    Car will not start without pressing gas pedal to keep idle speed up. If I keep idle at 900 RPM or higher it runs as long as foot is on gas pedal. It then stalls out when I take foot off gas pedal. No...


    Have the idle bypass valve checked, also called idle air control valve.
    If that valve is stuck in the closed position, it's not allowing the fuel to bypass the throttle plate to keep it idling, resulting in stalling, but will keep engine running if the pedal is pushed down.

    May 14, 2010 | 2000 Toyota Camry Solara

    1 Answer

    The horn chirps on my ford f-150 when i push the brake pedal in


    Seems like a short in the wiring between the brakes and horn

    Nov 08, 2009 | 2002 Ford F150 Regular Cab

    2 Answers

    Ford f-150 will crank but not start sounds like it wants to turn over. can hear full pump hum. new starter, new battery,. if i hit the gas pedel a lil while starting truck it will keep running but runs...


    I had the same problem but I did two fixes for it (1) when I bought the truck several years ago the duel tank switch was pushed in but i never fixed it and just would switch tanks with the switch pushed into the dash. after awhile it acted like it didn't know what tank to draw from point is i finally replaced the switch and it ran, but still ran rough, (2) on the left side of the motor their is an EGR valve (it was green colored vacum hose) I replaced that vacum hose and now it runs great.

    Aug 11, 2009 | 1992 Ford F150 SuperCab

    1 Answer

    When push gas pedal, oil pressure goes up


    have you oil pressure sending unit checke/replaced

    May 26, 2009 | 1990 Ford F150

    1 Answer

    Clutch problem?


    Clarify please. When in gear & you take foot off the pedal it revs?
    Your explanation appears to say that when you push the clutch, to disengage clutch, engine revs, as it should, and when you remove your foot, from pedal & it engages, truck runs as it should. Are you serious, or just wasting our time?

    Feb 25, 2009 | 1996 Ford F150 Regular Cab

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    27 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Ford Experts

    yadayada
    yadayada

    Level 3 Expert

    76630 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22219 Answers

    fordexpert

    Level 3 Expert

    5537 Answers

    Are you a Ford Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...