Question about Ford Taurus

1 Answer

TRANS WAN'T CHANGE RPMS DON'T GO UP OR DOWM.CHECK ENGINE LIGHT STAYS ON

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Ford Master
  • 454 Answers

Get codes read at autozone then retry. or you can reset the whole system by unhooking your battery for a minute or so. that's exactly what the cmptr needs is a reboot. if you get check engine light again then have codes read.

Posted on May 07, 2015

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My `94 toyota camry 2.2L, in the morning starts fine the RPM is at 1100, then when it gets warm it goes dowm to 800 RPMs is that normal or it should stays at least between 900 or 1000RPMs, please somebody...


high idle on starting is normal as it is the same as a choke being on. When it drops back it should be around 900. However tacos in cars are not real accurate under a 1000 rpms so have it checked manually with a rev counter. Run the fault codes to check for a problem.

Feb 27, 2015 | 1994 Toyota Camry

2 Answers

1994 nissan altima sometimes sluggish at take off, high rpms when changing gears


This sounds like a slipping transmission , check the fluid level first and make sure its full, if its full then you have ****** problems and may need to have ****** rebuild done,

Another thing is to make sure the trans passing gear cable is connected at the throttle where the gas cable is.

Sep 03, 2012 | 1994 Nissan Altima

1 Answer

Traction control light on and engine power reduced


you could have a stuck switch .....check your traction control switch on your dashboard....engage and disengage it , while paying attention to the rpms...notice any change...if you do notice a change, then replace the switch....if no change, it is probably on the trans itself and should not be a dealer only fix....your local reliable trans shop should be able to fix you up without emptying your entire wallet.

Apr 22, 2012 | 2009 Chevrolet Impala

1 Answer

Auto Transmission problem: Feels like it doesnt shift into OD and accelerates slow as if it stays in one gear. When put in 1st, it feels like the park brake is up of you're riding the brakes.


have you check the oil level on trans and have you change the oil on the engine lately check the levels on both. Usually on engine is too much oil car drags and on trans if low oil it usually stays in gear to protect the trans. your car is telling you check oil. No lubrication some warning lights do not come up for trans

Jun 25, 2010 | 1991 Subaru Legacy

1 Answer

Transmission stays in low gear. just changed the


the transmission fail safe is reverse and 2nd. gear.you probably missed reconnecting a large harness connector not near the trans but in the rear of the engine compartment. looc along the area behind the strut towers don toward the trans or right behind the engine.

Feb 16, 2010 | 2000 Ford Taurus

1 Answer

2001 Isuzu Rodeo Check Engine Light flashes when accelerating.


I would change the trans flter, trans fluid, and have the linkage on the trans adjusted.

Jul 21, 2009 | 2001 Isuzu Rodeo

1 Answer

01 Chrysler T&C Transmission Problem 3.3L engine


try having the transmission module re-flashed.

Mar 14, 2009 | 2001 Chrysler Town & Country

1 Answer

Vw automatic trans won't shift


The 01M and 09A automatic transmissions do not have a dipstick and procedure requires measuring and maintaining a specified ATF temperature (which is neither cold or hot, but in between) during the ATF level checking. Special Volkswagen tools are required for this operation and it is therefore recommended that ATF level checking on 01M/09A transmissions be left to an authorized VW dealer.

Mar 04, 2009 | 2000 Volkswagen Golf

2 Answers

Transmission-overdrive not working properly


check the transmission fluid first .
============
overdrive allows the engine to run at lower RPM's , which increases the fuel
economy and also the transmission runs cooler

Dec 15, 2008 | 1989 Ford Ranger

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...