Question about 2010 Ford F-150

1 Answer

2010 F150 dual control heater. Driver side works but passenger side doesn't. Any suggestions?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Ford Master
  • 10,875 Answers

The door inside heater may not be moving

Posted on Mar 31, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

tripletauto
  • 1450 Answers

SOURCE: 2004 silverado ac heater problem

try unhooking battery for a few minutes this will cause actuators to do a full sweep and reset. if it is still stuck then will need to replace the actuator for blend door on that side

Posted on Dec 31, 2008

SOURCE: 2004 chevy silverado 1500 a/c heater

when my truck is at an idle, it won't put out any heat in the cab, same thing in the summer with the A/C, what's the fix for it ?

Posted on Mar 11, 2009

  • 54 Answers

SOURCE: 2004 chevy tahoe, dual climate control, blowing different temps

Its more then likely the temp door broken or temp door motor broken/stuck. There is 2-3 of these motors under the dash on the side of the evap/heater core box. Some require extensive labor to replace, good luck

Posted on Jul 29, 2009

  • 1 Answer

SOURCE: 99 Buick Regal LS dual climate control. No heat passenger side.

the motor for the passenger side
blend door is shot

Posted on Jan 12, 2010

  • 1 Answer

SOURCE: Passenger window won't work using the driver side control switch

Open the window with the local button and keep the button pressed for 3 seconds after it has fully opened. Then close the window and keep the button pressed for 3 seconds after it has fully closed. This calibrates the position of the window which it lost when you changed the battery. Good luck

Posted on Apr 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2010 f150 lariat dual climate and passenger side blows cold and driver side is warm I don't hear any clicking from changing the temps like they say u hear it the blend door how do I diagnose


Some vehicles have a DCCV that controls flow of coolant to one side and the other. Don't know if yours does or not. And you won't hear an electric blend door motor very easily. don-ohio

Jan 27, 2017 | 2010 Ford F-150

1 Answer

2010 F150 Lariat. Dual climate control works only on passenger side. Rear temperature controls work fine. Driver side or left vents only blow hot air. Regardless if AC is turned on or temperature...


If the driver's blend door actuator has failed completely, or the wiring to it is damaged, you will not hear any clicking. Check for appropriate voltage at the blend door actuator, and determine from there if it's the actuator or the control unit.

Dec 20, 2016 | 2010 Ford F-150

1 Answer

My 2010 F150 Lariat. The heater blows warm air on driver side but blows cold air on passenger side. What could be the problem?


Does it have dual zone climate? If so, you have to adjust the passenger side. If it still doesn't work, check for vacuum hose off in engine compartment, going into the firewall.

Dec 03, 2016 | 2010 Ford F-150

2 Answers

2010 Acadia heater not blowing air out


sounds like the blend doors are stuck shut. when you switch it to defrost does the air come out the windshield vents?

Feb 02, 2016 | 2010 GMC Acadia

2 Answers

Got a1997 cadillac deville got heat on passengers side no heat on drivers side could you tell me the problem.no defrost on drivers side either help please


DTC B1340 Air Mix Door #1 Movement Problem !
The heater and A/C programmer supplies voltage to an internal motor that drives the air mix door. The heater and A/C programmer monitors the air mix door position feedback from a sensor on the motor. If the air mix door is requested to move but the feedback voltage does not change, the heater and A/C programmer will store DTC B1340. If the air mix door feedback indicates that the feedback is near the hot or the cold extreme, the DTC will not set. Evaluate the operation of the air mix door through self diagnostics as described in the test description.
Test Description
Perform the Diagnostic System Check before continuing with the diagnosis of this DTC.
A Scan Tool allows for the direct control of the air mix door by observing the following conditions:
• The air mix door position feedback value
• The value`s difference from the air mix door commanded position value
These readings indicate a fault internal to the heater and A/C programmer in the air mix door sensor feedback.

Did you perform the Diagnostic System Check?
--
Go to Step 2
Go to Diagnostic System Check
2
With the engine running, connect a Scan Tool .
Turn the dual zone to OFF (passenger temperature offset at 0 or OFF).
Exercise the suspect actuator using the temperature control on the control assembly.
Is the door being commanded (COM) to the proper high and low values?
COM High 100 %
COM Low 0 %
Go to Step 3
Go to Step 4

If you are unfamilier with this , i suggest you take it to a ASE certified repair shop or the dealer .

Jan 25, 2016 | Cadillac Cars & Trucks

1 Answer

Heater on passenger side stopped working, fan still works properly. Driver side is ok, any helpful link?


Dual climate control. They actuator on the passenger side at the center console is bad or the controller is bad. Have the codes read. One is $30, one is $300+

Dec 13, 2015 | 2010 Dodge Grand Caravan

1 Answer

2010 journey passenger side blows cold air when heater is on


Sounds like the damper flap is stuck or broken if you have the dual heater controll. You can try to reset it by setting both sides to cold shut the car off after you get cold on both sides. Then restart car and set heat to high on both sides. If that won't work you will have to take alook at the door actuator motors. Not much fun but can be done. At this point you may want to take your car to the dealership I'm told the repair is around 500.00 to 1000.00

Feb 24, 2015 | 2010 Dodge Journey

1 Answer

The heater is only working on the passenger side in my 2005 impala. the driver side is blowing cold air. please help


Do you have dual zone heat and cooling controls?
If so......the drivers side air flow control unit on the heater assembly is not working.
It is mounted on the heater assembly and can usually be accessed through the glove compartment to change it.
The stepper motor on these units fails often.
This should be the problem on your car 99%...if you have a separate heat/cooling control for driver and passenger areas.

Oct 29, 2009 | 2004 Chevrolet Impala

1 Answer

1996 Buick Park Ave -Hot air on driver side -Cold air pass. side


Behind the glove box you will see the heater box. On top of the heater box you will see a set of wires going to a small controller box that has an arm on it. It is probably not working and you can only by them at the dealer. It is the dual climate controller and cost approx. $100.

Jan 20, 2009 | 1996 Buick Park Avenue

Not finding what you are looking for?
2010 Ford F-150 Logo

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...