Question about 2006 Honda Odyssey

1 Answer

?How do I install a Glove box stopper arm 2006 Honda Odyssey?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 58 Answers

There should be 2 glove box stoppers on the sides of the glove box in the 2006 Odyssey. you have to thread the part while holding the glove box semi-closed (about half way should do), then press the part in place. If you need more details, please provide more details in your question.

Posted on Apr 21, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Brian032472
  • 150 Answers

SOURCE: How to change the HEPA cabin filter in a 2006 Honda Civic

Open the glove box and there are push out tabs on the left and right side pop them out. Now watch it because you are about to dump the contents of your glove box on the floor. let the box hang freely from the lower hinge and look in the back. You will see a white panel that pulls out the panel has a tray attached with the filter element in it remove old element and replace with new 20ish bucks at the parts store lots more at the dealer. re-install filter tray and reverse your removal steps to re-install. Recommended approx 15k or annually

Posted on Nov 04, 2008

savdragon
  • 37 Answers

SOURCE: glove box release so I can change the hepa filter

The procedure for removing the cabin air filter lists to remove the glove box housing. You usually can either ....1 empty out glove box, look and see if there are two tabs (stops) on the box part that tilts out. Often times the plastic box can be squeeze in at both sides to clear the housing. This allows it to tilt all the way down and you're off. or 2- empty out the glove box and completely remove the assembly. This requires removing 4 to 6 screws on sides and likely on bottom to pull out whole housing. Once out the rest should be very obvious.

Posted on Mar 18, 2009

  • 58 Answers

SOURCE: How to change the cabin filter on 2006 Honda Odyssey?

I will never understand why this service is so expensive at the dealership.
I made a video showing how this is done:   (I would recommend watching the video in HQ and full screen)

Posted on Apr 21, 2009

  • 58 Answers

SOURCE: 2004 honda odyssey radio code glove box number is

The radio code is a series of only 5 numbers. The van had 3 copies of this code and the dealer probably placed one of them somewhere inside or on the owners manual.

Posted on Aug 12, 2009

philschneide
  • 448 Answers

SOURCE: replace fog light bulb for 2006 Honda Odyssey

Touring Model
Use a wrench to remove the mounting bolt from the underbody through the hole in the splash shield.
Remove the fog light assembly from the bumper by pulling its inner edge first, then the whole assembly out of the bumper.
Remove the electrical connector from the bulb by pushing on the tab and pulling the connector down.
Remove the bulb from the fog light assembly by turning it one quarter turn counterclockwise.
Push the electrical connector onto the new bulb.
Turn on the fog lights to test the new bulb.
Reinstall the fog light assembly into the bumper. Tighten the mounting bolt.
Insert the new bulb into the assembly and turn it one-quarter turn clockwise to lock it in place.
Hope this helps you.

Posted on Nov 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Odssey 2000 navigation conversation to english


call honda and ask.
or read the operators guide in glove box , if it even has this.
it might require, reprogramming it. call them.

Dec 11, 2013 | 2000 Honda Odyssey

1 Answer

The battery died on my 2006 Odyssey. I replaced


Check with the dealer... if you purchased used go to any dealer with ownership papers and the service department can help.

Jul 01, 2010 | 2006 Honda Odyssey

1 Answer

Replace pollen filter in 2008 honda odyssey


The pollen filters are located in the HVAC box behind the glove box. While holding the glove box open, unclip the glove box damper (left side). Then remove the glove box stops on each side, flip the glove box down. Pull the pollen filter housing from the blower unit by releasing the clips on both sides. Replace the filter in the housing make sure the arrows printed on the new filter are pointing down. Reinstall all removed parts. -hope this helps.

Mar 02, 2010 | 2007 Honda Odyssey

2 Answers

My 2006 honda odyssey touring now asks for a pin for the navigatin system. and now is locked out how can i reset?


Open the glove box and look for and sticker with a 5 digit code, that is the navi unlock code, if not i have acess to get that code for you!

Aug 28, 2009 | 2006 Honda Odyssey

1 Answer

How do you install a dust and pollen filter in a 2007 honda odyssey?


open the glove box. and you will see on the right side a small plastic hanger unclip it and you can pull down the glove box. the cabin filter is behind a small panel above the blower motor.

Jul 11, 2009 | 2007 Honda Odyssey

1 Answer

How to change cabin filter in 2006 Honda Odyssey EXL model


Remove the glove box housing. Remove the dust and pollen filter assembly from the evaporator. Remove the filter from the housing, and replace the filter. Install in reverse order.

Jul 10, 2009 | 2006 Honda Odyssey

1 Answer

How to replace air filter for 2007 Odyssey


Hw to change air filte rin 2007 Honda Odyssey

The problem with other web instructions is little guidance on how exactly to remove the glove box. First, the little cover over the control am needs to be pulled off (down towards you). Either fingers or a screwdriver.

Next, trickiest part is removing the retaining tabs. See instructions here: http://techinfo.honda.com/rjanisis/pubs/AI/AII38194.pdf

Basicaly, there is no way to ge behind the glove box to compress the release tabs. So insert a scredrver into the plastic tab cover from the insider of the glove box and just pull towards you until it pops out. When reinserting just place back (with the retainer cylinders poking back through the opening from inside the glove box) and press back in until it snaps.

On the 07 Ody, once you ave the control arm released and the two retaining tabs removed, the glove box should fold down completely. Then just press towards each other the two black end tabls holding the ac filter compartment door. Took me 30 min to figure out, hopefully with this should take you 5 ...

Jun 30, 2009 | 2006 Honda Odyssey

1 Answer

How to access the cabin air filter on the 2006 Odyssey


While holding the lower glove box, release the damper and remove the glove box stop on each side.
Remove the bolts, then remove teh lower glove box. Install the lower glove box in the reverse order of removal.

30067ae.gif
a0c55ba.gif

May 23, 2009 | 2005 Honda Odyssey

1 Answer

How to change the cabin filter on 2006 Honda Odyssey?


I will never understand why this service is so expensive at the dealership.
I made a video showing how this is done:   (I would recommend watching the video in HQ and full screen)

Apr 19, 2009 | 2006 Honda Odyssey

1 Answer

Glove box release so I can change the hepa filter on my 2006 Honda Odyssey


The procedure for removing the cabin air filter lists to remove the glove box housing. You usually can either ....1 empty out glove box, look and see if there are two tabs (stops) on the box part that tilts out. Often times the plastic box can be squeeze in at both sides to clear the housing. This allows it to tilt all the way down and you're off. or 2- empty out the glove box and completely remove the assembly. This requires removing 4 to 6 screws on sides and likely on bottom to pull out whole housing. Once out the rest should be very obvious.

Mar 18, 2009 | 2006 Honda Odyssey

Not finding what you are looking for?
2006 Honda Odyssey Logo

Related Topics:

148 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...