Question about 2004 Toyota Sienna LE
The check light on the instrument panel is flashing
-Use scan tool to read the code and find out what cause that and
Posted on May 18, 2015
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: maintenance light flashing
h) Engine Oil Replacement Reminder
Light (for vehicles sold in U.S.A.)
This light reminds you when to replace
the engine oil.
This light will come on when the ignition
key is turned to “ON” and will go off after
about a few seconds.
When you drive for about 8000 km (5000
miles) after the engine oil replacement,
this light illuminates for about 3 seconds
and then flashes for about 12 seconds
with the ignition key turned to “ON” position.
If you continue driving without the
engine oil replacement, and if the driving
range exceeds 12000 km (7500 miles), the
light will come on after the ignition key is
turned to “ON” position. The light will remain
If the light is flashing, we recommend that
you replace the engine oil at an early
opportunity depending on the driving and
road condition. If the light comes on, replace
it as soon as possible.
You need to reset the light after the engine
oil replacement. Reset the light by
following the procedure below:
1. Turn the ignition key to the “OFF” position
with the odometer reading shown.
(For details, see “Odometer and two
trip meters” on page 136 in this Section.)
2. Turn the ignition key to the “ON” position
while holding down the trip meter
Hold down the button until the light goes
off. Before the light goes off, it illuminates
for 3 seconds, flashes for 2 seconds and
illuminates for 1 second.
If the system fails to reset, the light will
I copied this from page 143 of the owners manual for the 2004 4Runner
Posted on Jun 04, 2009
check brake fliud level and wires and connectoins to sensors if look good have vehicle scanned for trouble code some auto stores such as auto zone / advanced auto scan for free the code will give u a start point
Posted on Nov 01, 2009
are you sure that your fuses are all good?because it's highly impossible for all off your dash lights and your heater/a/c light burn out at the same time.and yes it is controlled all together.make sure that your dimmer switch is not turned all the way down cause this will cause them to not work.i believe that the dashboard alone has either 3 or 4 bulbs so im pretty sure it has to be a fuse or your dimmer switch.please try these options first ok. hope this info helps.take care and good luck, manny
Posted on Apr 08, 2010
SOURCE: 1994 Toyota Camry LE V6,
For what might be an immedate remedy, remove the negative battery clamp and keep it off for at least 5 minutes, then hook it back up and start it back up-see if the lights come back on.If they do, you need to get the ECM scanned and need to find a OBDI scanner with the Toyota adapter to get codes.
Posted on Apr 29, 2011
SOURCE: where is the fuse box
The turn signal is on an intermittent switch. The relay or fuse under the hood might be bad. If you can't find the one inside, look for a cover that says FUSE BOX on it. If no luck, refer to your owners manual.
Posted on Jun 18, 2011
Tips for a great answer:
Oct 07, 2016 | 2004 Toyota Matrix
on Jan 02, 2010 | Toyota Camry Cars & Trucks
May 02, 2015 | 2000 Toyota Sienna LE
Mar 03, 2015 | 2004 Toyota Camry
Apr 03, 2014 | 2007 Toyota Corolla LE
Nov 28, 2012 | 2005 Toyota Sienna LE
Nov 23, 2010 | 2004 Chevrolet Suburban
Mar 03, 2009 | 1993 Toyota Camry V6
Jan 23, 2009 | 2004 Toyota Sienna
67 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: