Question about Cars & Trucks

1 Answer

Where is the emergency override panel for the imobilisor located

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 2,039 Answers

Dont understand your question

Posted on Mar 29, 2015


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer


Put the emergency brake on. Find the shifter lock override slot, which is usually located on the shifter console close to the shift lever. The slot will be plugged with a plastic cap. Remove the cap and push down on the button with a nail file or other pointed object.

May 06, 2017 | Pontiac Cars & Trucks

1 Answer

Wheel is locked up will not engage shifter move from Park to drive

1 Set the emergency brake.
2 Insert key into the ignition and turn the ignition switch to the "ON" or "RUN" position. It is not necessary to start the engine.
3 Locate the shift lock override slot located on the shifter console near the shifter lever. Normally, the slot is plugged with a small plastic cap. Remove the cap.
4 Insert a small screwdriver, nail file, key or similarly shaped object into the override slot, push down and hold
5 While continuing to hold down the shift override mechanism, depress the brake pedal.
6 Now, grasp the shifter, push in the release button located on the shifter as you normally do and then move the shifter to the desired gear. If you've completed these steps with the engine off, move the shifter to the Neutral position to start the engine.

Dont know if this helps

Oct 23, 2016 | Cars & Trucks

1 Answer

Where is flasher relay located?

Most of the newer relays are built into the emergency flasher button assembly. Check to see if the emergency flashers work. But, some are are located close to the kick panel on driver side. It will be a full fuse panel with a lot of relays and minimal fuses. I dont know exact location because I have worked on so many different vehicles.

Oct 08, 2015 | 1992 Jeep Cherokee Limited

2 Answers

How can I turn off my interior lights on a 2000 Yukon XL 1500

You can try pushing the override button located right under headlight dial.

Apr 04, 2015 | 2000 GMC Yukon XL

1 Answer

Where do i find the imobilisor on toyota celica 1998

the immobilizer module is usually installed under the dash behind the instrumentation panel. lie down under the steering column and with the help of a flash, read some of the labels.

Jun 02, 2014 | 1998 Toyota Celica

1 Answer

Is there anyway a 2013 mini convertibles roof can open without the key being in? Thanks

Only by using the emergency manual override process which you'll find in the vehicle owners' handbook. But it is intended for occasional emergency use only such as when the roof electrics fail. Regular usage can cause additional problems. If the electrics fail then it's recommended to use manual override to close the roof and to keep it that way until you can get the roof mechanism fixed. RV Roof Repair Leaks Repair

Jan 16, 2014 | Cars & Trucks

1 Answer

89 porsche carrera 3.2 battery went flat, now recharged, imobilisor (pa1000) now wont let the car start or even turnover, how to reset/override?

Theres a keyhole on the back of the siren in the engine bay, if the key is in your possession you can turn off the alarm with this - Hopefully* Also the control boxes for the alarm/immobiliser are usually under the front seats, there are 3 boxes throughout the car and they can be hard to find, each has a fuse - check the fuses and replace any that are blown - plugging and replugging the fuses may reset the immobiliser anyway I can't find a manual for it but i'm looking - try this out first and tell me what happens - there IS a proper reset procedure - but it's not exactly broadcast. i'll do my best to track down the manual for the pa1000, but it is an obsolete system and will be hard to find.

Jan 26, 2010 | Porsche Carrera Cars & Trucks

4 Answers

Car will not go out of park 2002 mountaineer is stuck in park - will crank but cannot put in gear


Check your shift interlock switch on the brake pedal. If it is out of alignment or has failed the shifter will not unlock to enable a gear selection.

Also - a fuse may be blown, or you may have a taillight out.

You can manually unlock it in emergency situations.
Taken from P.181 of the manual......

Brake-shift interlock
This vehicle is equipped with a brake-shift interlock feature that prevents
the gearshift lever from being moved from P (Park) when the ignition is
in the ON position unless brake pedal is depressed.
If you cannot move the gearshift lever out of P (Park) with ignition in
the ON position and the brake pedal depressed:
1. Apply the parking brake, turn ignition key to LOCK, then remove the
2. Locate the access cover plate to
the brake-shift interlock override. It
is located on the underside of the
steering column.
3. Rotate the access panel
(counterclockwise) with a flat head
screw driver until it is lined up to
the access hole in the open position.
4. Insert a tool (or screw driver) into the access hole to override the
brake-shift interlock. Apply the brake and shift into Neutral.
5. Return the cover plate (rotate
clockwise) to the closed position.
Start the vehicle.

If it is necessary to use the above procedure to move the gearshift lever,
it is possible that a fuse has blown or the vehicle’s brakelamps are not
operating properly. Refer to Fuses and relays in the Roadside

Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.

Apr 06, 2009 | 2002 Mercury Mountaineer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15387 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides