Question about 2004 Chrysler Crossfire

1 Answer

Hesitate during take off

While driving coming to a stop then taking back off vehicle hesitates

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 386 Answers

Hello,
You should add some fuel injector cleaner into your gas tank to clean the injectors as you drive.
Good Luck!
Rich Lilja

Posted on Apr 03, 2015

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 76 Answers

SOURCE: Transmission

This is not uncommon, chrysler spec say that it may take up to 5 seconds to engage when cold. Make sure your flid is topped up to the proper level and I recommend a trans tune every 50,000 kms. Also, your dealer can do a quick learn, which resets all the factory values(recommended after every trans related repair).

Posted on Nov 18, 2008

  • 12 Answers

SOURCE: 2003 300M, vehicle "jerks" when slowing to 30 mph

If you just had a trans service.the CVI's in the trans controller will need to be reset.

Posted on Apr 11, 2009

  • 295 Answers

SOURCE: 2004 Chrysler Sebring it hesitates when I crank it

The fuel filter should be changed first.
The engine fuel pressure over night is bleeding down into the fuel tank. I would suggest a tune up . If the condition continues after a tune up. The fuel pump is starting to go. You should then have a mechanic check out the fuel system and have the vehicle diagnose.

Posted on Jul 16, 2009

emissionwiz
  • 77202 Answers

SOURCE: 1999 chrylser lhs hesitates while driving and randomly shuts off while driving

Hello

The engine and the automatic transmission in this vehicle are computer controlled and in most cases when a fault occurs a fault code is stored in the memory of the computer control module. There are exception to this, such as the Mass Airflow Meter and fuel pressure problems. What must be done is to have all the basic testing done such as a scan of the system for fault codes as well as a check with a live data scanner tool for engine functions that are not within range of normal, a trained technician is required to know what is correct and what isn't, then based on careful diagnostics done from a factory repair manual the correct part is replaced or the wiring repaired or the computer replaced (known as the PCM), which is very rarely the problem. Other basic checks must be done as well such as mechanical problems with the engine as well as engine state of tune and mileage on the engine. The transmission can have mechanical issues as well such as no gear engagement at all or a failed pump or other pressure related problems.


Posted on Sep 28, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Temperature light and hesitation during acceleration.


You could have air in your coolant, causing this false reading. the hesitation could be related, if the air 'bubble' found its way to the coolant sensor.

Jan 09, 2014 | 2000 Mercury Grand Marquis

1 Answer

1997 Plymouth Voyager 3.3 dies at idle hesitates during acceleration


It should show up with a P code as it misfires. If it doesn't, check the engine temperature sensor and O2 sensor.

Mar 01, 2017 | Cars & Trucks

2 Answers

Vehicle: 1998 Nissan Pathfinder SE V6 3.3L Problem: Vehicle has been hesitating during acceleration and occassionally stalling. After stopping and restarting, vehicle has been extremely hesitant. The...


Hello,
When the MAF on most vehicles reach a point of preventing the engine from starting, you can usually just unplug it and the engine will start. If that doesn't work-
You may want to try having the O2 sensor, ( Oxygen sensor ), checked. It works with other components of the emission system and can cause similar symptoms as the MAF, including preventing the engine from starting.

Donnie

Feb 21, 2011 | 1998 Nissan Pathfinder

1 Answer

'93 Celica GT 2.2L w/ Auto Trans. hesitates, jerks


hi,

sounds like a vacuum leak, injectors clogged, bad plugs, plug wires or maybe low tranny fluid or combo one all, have it dynoed to save yourself some money of course.

good luck

J

Jun 29, 2009 | 1993 Toyota Celica

1 Answer

Car shifts hard


get the vehicle scanned at a repair shop. address the codes if there are any present. start there.

Dec 11, 2017 | 2001 Pontiac Grand Am SE

1 Answer

2005 jeep grand cherokee limited 5.7 hemi vehicles hesitates


The egr valve is located on the front of the right cylinder head. It has a tube attached to it and going to the intake manifold.It has failed and is why your jeep is running rough and hesitating. Replace it and it will fix your driveabllity issues. Disconnect the battery for 2 min to clear the code.

Apr 01, 2009 | 2005 Jeep Grand Cherokee

1 Answer

Van occasionally stalls. Lurches after leaving a stop sign


I had somewhat the same problem on my 03 chev venture van. It was the tranny slipping or rather not engaging. When you try to pull away from a stopped position the vehicle start to accelerate momentarily then hesitate then **** forward with a loud thunk. Turned out to be a solenoid or sensor in the tranny. The dealership at first refused to do anything saying it was normal and to allow more time after putting it in gear. After I proved to them that it was not normal ( by taking them on a test drive in my vehicle then in one of thiers) they agreed to fix it. Worked great for 20-30000K then came back. Now have 260,000k so it is more nuisance than a problem at least at this point.
Check your fluids and possibly look into using a transmission additive designed to stop slippage

Aug 31, 2008 | 2003 Chevrolet Venture Passanger

2 Answers

Vehicle hesitates when you accelerate .


make sure you have the correct spark plugs(2)check the throttle position sensor on the car,as most people would be driving about with the throttle on the floor car feels fine.but as in normal driving anyone only uses the first half of the pedal and this is where most wear takes place and sometimes causes hesitation when driving.best of luck.

Jul 17, 2008 | 2000 Volvo S70

Not finding what you are looking for?
2004 Chrysler Crossfire Logo

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...