Question about 1998 Chevrolet K1500

3 Answers

Wheres the fuel shut off switch located?

I'm not getting any power to fuel pump relay!

Posted by on

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chevrolet Master
  • 2,899 Answers

There should be a fuse in front of the relay. The fuse could be under the hood near the battery or near the firewall.
Some fuses are under the dash next to driver.
Hope this helps.

Posted on Mar 29, 2015

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 2,428 Answers

The relay is located in the glove box behind a panal that says relays .
But thats not your problem The fuel system is backed up through the oil pressure sending unit .So even if the relay burned out say on the highway the oil pressure unit would still supply voltage to the pump .And if the relay wore bad it would still start it would just crank for a longer time .
Check your fuel filter remove it see if its cloged if not put a plastic bottle over the line comeing from the pump turn the key to run do you get fuel from the pump .No most likely you need a new fuel pump you could check the wireing to the pump but its on top of the tank if you dropped the tank .Ive been their done it
Good luck

Posted on Mar 30, 2015

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 14,585 Answers

Not the kill switch, it's after the relay.

Posted on Mar 29, 2015

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1989 f-250 inertia fuel shut-off switch switch location


This should be in the owner's manual. I found the below on autozone.com, their repair help location:
An inertia switch is used as a safety device in the fuel system. The inertia switch is located in the cab, generally under the dashboard on the right side. It is designed to open the fuel pump power circuit in the event of a collision. The switch is reset by pushing each of 2 buttons on the switch simultaneously (some models use switches with only one reset button). The inertia switch should not be reset until the fuel system has been inspected for damage or leaks.
When the ignition switch is ON , it turns the EEC power relay ON . The EEC power relay provides power to the powertrain control module (PCM) and the control side of the fuel pump relay. Power for the fuel pump(s) is supplied through a fuse link or high current fuse attached to the starter solenoid (battery side). From the fuse link or high current fuse, current flows through the fuel pump relay and inertia switch to the fuel pump(s). The fuel pump relay is controlled by the PCM.
When the ignition switch is turned ON , the fuel pump(s) will operate. If the ignition switch is not turned to the START position the PCM will shut the fuel pump(s) OFF after 1 second. The PCM will operate the fuel pump(s) operate the fuel pump(s) when the ignition switch is turn to START position to provide fuel while cranking.
After the engine starts, the PCM will continue to operate the fuel pump(s) unless the engine stops, drops below 120 rpm or the inertia switch is tripped.

Dec 28, 2013 | 1989 Ford F 250

1 Answer

Wheres the fuel pump relay on a 2003 kia optima 4 cylinder?


The pump relay is in the relay - fuse box in the engine compartment. Your owners manual should have the details.

Jun 11, 2013 | Cars & Trucks

1 Answer

Car will turn over but won't start. Through the


No noise from fuel pump when you turn over the car .First thing get voltage at fuel pump relay checked, is there 12 volt to the relay.If no, then problem is again the relay.--------- To reconfirm the problem, try other test, that is remove the relay and by pass the relay terminals with a jumper wire .Then with 12 volt external battery give power to fuel pump connector and see, if the fuel pump starts, then its clear that fuel pump relay is faulty.----------- Also other problem can be fuel pump inertia switch.If the inertia switch is faulty then also fuel pump will not start.-------- The fuel pump relay on a 1995 Ford Explorer is in the power distribution
box, in the engine compartment, driver's side near the firewall.----------
The fuel pump inertia switch is in the right front passenger area
it is below the dash but above the carpet in the right hand corner.--------
Its a push button type inertia switch.
--------
Fuel Pump Activation
When ignition switch is turned to START position, PCM operates fuel pump relay to provide fuel for starting engine. PCM senses engine speed and shuts off fuel pump by opening ground circuit to fuel pump relay when engine stops or engine speed drops to less than 120 RPM. When ignition switch is in ON position, EEC power relay is energized (contacts closed). Power is provided to fuel pump relay and timer in PCM. Fuel pump receives power through fuel pump relay contacts.
Inertia Fuel Shutoff (IFS) Switch
All models use an electrical interrupt switch in fuel system. During a collision or vehicle rollover, electrical contacts within inertia switch open, shutting off fuel supply to electric fuel pump. Fuel supply is interrupted even when engine is running.
A reset button is located on switch assembly. If electrical circuit trips, vehicle will not restart until switch is reset. Fuel system should be inspected before resetting switch.
IFS switch is located under instrument panel, near right side of transmission hump.
----------- If the fuel pump relay, the inertia switch and fuel pump all checked ok, and fuel pump is working with direct 12 volt source to fuel pump.Then problem relates to computer.The computer (power control module, PCM) is faulty and has to be replaced.--------- This will help.Thanks.Helpmech.

Jul 17, 2011 | 1995 Ford Explorer

1 Answer

Wheres is the fuel fuse located on a windstar 1998


The fuse for the fuel pump is located in the "N" position in the power distribution box located in the engine compartment (see pictures below for both). If you notice there is also a fuel pump relay there as well that you might want to check. I don't know if you have checked the fuel pump cut off switch as well. That is located behind the trim panel by the drivers left foot. I hope this helps and good luck on getting fuel and not having to replace the pump.clifford224_8.gif

Feb 28, 2011 | 1998 Ford Windstar

1 Answer

Wheres fuel pump cut off switch on 2005 ford e250


if you are talking about the inersa switch which shuts off fuel when you get into a crash it should be located behind the kick pannel on the passanger side (under the glove box behind the carpet cover where your feet go)

Dec 18, 2010 | 2004 Ford E250

1 Answer

Wheres the fuel pump relay located at on a 1994 ford escort


Check the fuel pump reset which is usually on the drivers side in the trunk under the mat. By-pass it and see if the fuel pump will start.They can become corroded and may be your problem. Fuel pump relay should be under the hood and marked as FI or Fpump etc. New Answer: the relay is in front of the shifter under the dash if you get the panels off (shifter cover , lower center panel and left center panel you can see it and the PCM power relay if you lay on passenger floor and look to rear of center area.

Dec 14, 2010 | 1994 Ford Escort

1 Answer

No power to fuel pump


check the tan- lt green wire on the fuel relay that is located on the right fender, mine wasn't pushed in all the way, this wire shut down injectors and fuel pump, if you are looking for the shut off switch to reset the relay, it is on the passagers side floor board under the dash, gas two wires, orange and pink, I don't remember the color of the stripes, I removed this switch and wired them together without a problem

Mar 27, 2010 | 1988 Ford Bronco II

1 Answer

We just replaced the fuel pump on my 96 gmc 1500. and it has no power going to it, as it did before... it has an inline fuse. wheres the fuse on it?


the fuel pump runs off the engines oil pressure switch upon starting. when the oil pressure is up to normal psi the fuel pump relay takes over until you shut the engine off.

Mar 03, 2010 | 1995 GMC Sierra C1500

1 Answer

2000 ranger fuse diagram


Fuel Pump relay switch is in the main box usually located on the drivers side Fender in a black box. According to the owner's manual in the power distribution box in the engine
compartment (Ford recommends disconnecting your battery)
Relay # 5 is the fuel pump relay , and also in the PD BOX is a 20 amp mini-fuse
for the fuel pump relay + RAP module in location # 9


( P.S. - don't forget your fuel pump inertia switch , in the right front passenger area ,
by the right front kick panel )Sometimes this gets kicked by passenger or if the car is bummed hard it could set this item to shut down fuel system. Best of Luck

Aug 28, 2009 | 2000 Ford Ranger SuperCab

1 Answer

Fuel pump shut off switch


no it doesn't. the fuel pum has a relay that is located in the junction box under the hood if your vehicle is not starting because your not getting fuel check the relay. I use the a/c clutch relay to switch with the fuel pump relay if the vehicle starts just replace the relay if the vehicle doesn't start then you have a bad fuel pump...please rate

Oct 04, 2008 | 2002 Dodge Neon

Not finding what you are looking for?
1998 Chevrolet K1500 Logo

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...