Question about Cars & Trucks

1 Answer

Will not stay in low side .goes in and then jumps out

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Cars & Trucks Master
  • 880 Answers

Linkage is not allowing for the full engagement of the low gear. one test would be to remove linkage at the transmission and manually placing it in low gear and see the difference if any

Posted on Mar 30, 2015

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 1998 Chevy Blazer. My gas gauge does not work properly. The gas gauge stay's on FULL at all times no matter how much gas is in it. When it get's low on fuel the gas gauge start's to jump back and...


It has 2 possible solutions 1) fuel sending unit is going bad which the tank has to be dropped to change, 2) you have a bad cluster panel. Hope this helps

Dec 18, 2013 | 1998 Chevrolet Blazer

1 Answer

Climate control fan stays on after jump start, cycling from low to high


Blower motor resister is bad.Easy to remove,it's located by blower motor,click here to see what it looks like.

Jan 17, 2013 | 1998 Nissan Maxima

1 Answer

Jump low pressure switch


Actually, you jump the two slots on the harness, which simulates the switch closing due to pressure.

You can just use a short piece of 12V type wiring to connect from one plug side to the other in the harness that goes to the switch.

Mar 29, 2012 | 2003 Pontiac Grand Prix

1 Answer

I have a 98' Grand Marquis with a 4.6 engine. as


have the alternator checked. if the alternator is not charging the vehicle is only supplied with what power is stored in the battery. once the battery is dead there is nothing to charge it

Jul 26, 2011 | 1998 Mercury Grand Marquis

2 Answers

Low coolant light stays on and coolant level is not low


Many times vehicles have a coolant sensor mounted on the radiator that goes bad allowing the low coolant light to stay lit changing this sensor usually takes care of the light also make sure the wires running to the sensor are not shorted or broke.

Jan 29, 2011 | Ford Taurus Cars & Trucks

1 Answer

My light problem is i have low beam on right side no low on left side i turn highs on and right side goes out and high on left turns on then when back to lows beams and i pull turn signal to flash high...


If you have separate bulbs for the low and high beams(4 light system), if you pull the turn signal and hold it, all 4 lights will stay on until you release the turn signal. You need to replace the bright bulb on the right side and the low bulb on the left side. If your headlights only have one bulb on each side, then you will have to replace both of them to get everything to work.

Jan 04, 2011 | 2000 Ford Mustang

1 Answer

I have a 05 Pacifica, the air cond. compressor will not turn on. I did jump out the relay, the compressor comes on runs for a few seconds, the high side pressure goes to 300 psi, turns on the condensor...


when you jumped the relay it ran. did you check to see if the relay was good? if so it could be the high or low pressure sensors. they send the signal to the computer to turn on the a/c. presuures for the a/c is about 60 for the low side and 200 and up for the high depending on the temputure out side. need to check for codes

Jun 14, 2010 | 2005 Chrysler Pacifica

2 Answers

I turn the key to on i have power when i turn key to start it goes solid dead what is it


turn the head lights on and see if they stay on or if the car goes dead this could be a low battery or a bad connection at the battery

Feb 11, 2010 | 1997 Buick LeSabre

1 Answer

1998 ford exped v8 battery is good, but turn ignition key, battery goes dead. have a clickng sound in fuse box, battery will jump off and stay running but when i turn it off will not start back up


battery is low on voltage, it is either bad or the alternator is bad. after you jump start check volts at the battery . if volts are below 13.00 the alt is most likely bad. if volts are about 14.00 alt is good. battery is bad.

Jan 05, 2010 | 1998 Ford Expedition

1 Answer

What would make the AC clutch turn on an off repeatedly, approximately every 4 seconds on an 99 chevy Suburban 5.7L 4x4 LT? Only blows out hot air


low freon soumds to me.. jump out the low pressure cut out switch near the dryer...or jump clutch relay in the distribution center. with clutch ingauged hook up guages to check low and high side pressures... also easy trick go to auto store get a can of 134a freon with hose and add the can the clutch should stay inguaged longer and longer as you fill the sytem... with clutch inguaged rev motor up to 1500 the guage on the hose should be around 35 to 40 pounds if low add more

Aug 31, 2009 | Chevrolet Suburban 1500 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...