Question about 1994 Mazda Protege

1 Answer

Engine sputters and stalls out upon acceleration.... 1994 Mazda protege

Posted by Anonymous on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Mazda Master
  • 880 Answers

Replace the plugs and fuel filter and air filter and see if you get results

Posted on Mar 30, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: engine bogs and stalls

Check the air filter hose. My '99 Protege was idling rough and would sometimes shut off. The air filter hose was cracked half way around. I replaced it (easy just loosen two hose clamps and pull out the sensor) and the car is running fine.

Posted on Dec 27, 2008

  • 1 Answer

SOURCE: 2002 Mazda Protege acceleration problem

I had the same problem and found that the air admission tube was badly cracked.

Since this let air enter the engine downstream of the mass airflow sensor it is not measured so the engine ECU don't send the proper amount of fuel to provide the right air/fuel mixture. At higher RPM, the vacuum in the tube is enough to close the crack and hide the problem.

I temporarly repaired it with duct tape until I get the part.

Stephane

4cc37fa.jpg

Posted on May 27, 2009

Molson02536
  • 3854 Answers

SOURCE: Chevy S10 Pick 1995 - Sputters and almost stalls when accelerating.

You could have a dirty EGR valve, you can re move it from the manifold and clean it with Throttle body cleaner. Might as well buy two cans, since your cleaning the EGR, might as well clean out the throttle body too.
Spray the throttle body cleaner in to the throttle body with the engine running and try to keep it at 1000 rpm and then to 1500 rpm as you clean out the throttle body and let it idle down for 2 min then turn the engine off. Then turn the engine to the run position for 10 seconds and start and let idle, ro for a test drive and hope that solved the problem, if not there a few more things we can do which will consist for tune up.
Note: Clean the EGR first so you don't burn your self since the engine would still be cool before you clean the Throttle body.
Good luck and keep me posted.

Posted on Jun 01, 2009

  • 1 Answer

SOURCE: 2001 mazda protege keeps stalling

my 2001 mazda protege starts hard, idles low and high at various times (never normal) and it acts as though its going to stall at all times. sparks and wires are changed no help, changed air filter no help. any idea on what to do?

Posted on Nov 26, 2009

  • 16 Answers

SOURCE: 1992 Chevy S-10 Pickup 4.3L 6 Cyl. Engine sputters

SOUNDS LIKE MAYBE FUEL FILTER NEEDS REPLACE, AND OR EVEN SPARK PLUGS AND WIRES. A GOOD TUNE UP. IF YOU RUN LOW OCTANE FUEL YOU MAY TRY A CAN OF OCTANE BOOST, OBTAINED THRU THGE LOCAL PARTS STORE, IN WITH THE NEXT FILL UP. IT WOULD PROB BE A GOOD IDEA TO GET SOME INJECTOR CLEANER AND PUT IT IN WITH YOUR GAS TO SEE IF THAT HELPS.

Posted on Feb 17, 2010

Testimonial: "I put in injector cleaner and gas boost. No help. Will replace fuel filter. Could bad oxygen sensor cause this?"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my 1994 prrotoge run fine when the engine is cold but when it heats up it sometimes spits and sputters like there no power especially when you first take off


Check coolant temp sensor. This acts as the choke on FI engines and when they fail it can acts as if you stil have the choke on when engine is warm.

Mar 02, 2015 | 1994 Mazda Protege

1 Answer

I have a mazda protege 1.6 year 2000 the egr valve is open at all time i test a close one but the engine start to vibraye to much


Make sure the EGR ports aren't clogged with carbon. It can completely clog ports. EGR shouldn't be open at IDLE, but it will open upon accelerating.

-Scott

Feb 19, 2015 | 2000 Mazda Protege

2 Answers

Why does my 91 mazda b2200 sputter, knock off, and sometimes wont start back up


need more specifics, does this happen when it is cold, hot, upon acceleration, at idle or what?

Aug 31, 2014 | Cars & Trucks

1 Answer

Idling low during stop, hesitating acceleration


Could be dirty throttle body or needs tune up.fuel filter,air filter.

May 08, 2013 | 1991 Mazda Protege

1 Answer

My car is turning on but stalls I have a Volkswagen Jetta 06 2.5 engine. PLEASE HELP


Vehicle starts but stalls.These types of problems are very common on most of vehicles.There are few possibilities,that can cause stalling problem on vehicle.The vehicle brand and model may differ but problem is same.------I provide you few suggested help link to troubleshoot these issue and solve the problem:-----------
1995 Toyota Corolla: Stalls, Sputters and Pops Through Intake Manifold? http://whatisbyme.blogspot.in/2012/05/1995-toyota-corolla-stalls-sputters-and.html
-------------1994 Toyota 4Runner: Stalls and Stops While Driving? http://whatisbyme.blogspot.in/2012/05/1994-toyota-4runner-stalls-and-stops.html
-----------1992 Chevrolet stalls and shutdown? http://schematicsdiagram.blogspot.in/2012/04/1992-chevrolet-stalls-and-shutdown.html
-----------Dodge Dakota stalls, stumbles at idle. Has low fuel flow and runs hot? http://schematicsdiagram.blogspot.in/2012/03/dodge-dakota-stallsstumbles-at-idlehas.html
------------Engine stalls when gas is given? http://technoanswers.blogspot.in/2012/01/engine-stalls-when-gas-is-given.html
------------1990 mazda 323 stalls and quit running? http://technoanswers.blogspot.in/2012/02/1990-mazda-323-stalls-and-quit-running.html
------------Nissan Pathfinder stalls and bucks on Acceleration? http://technoanswers.blogspot.in/2012/02/nissan-pathfinder-stalls-and-bucks-on.html
------------Car stalls when MAF sensor is connected? http://technoanswers.blogspot.in/2012/01/car-stalls-when-maf-sensor-is-connected.html
-----------Car Engine Stalls While Driving? http://schematicsdiagram.blogspot.com/2011/12/car-engine-stalls-while-driving.html
--------- Stalls And Dies At Stop Sign? http://www.howtobyme.blogspot.com/2012/07/stalls-and-dies-at-stop-sign.html

-----------
These are few help links,that will help you to troubleshoot the issue and solve the problem.Please keep updated,if any more help required.Thanks.

Oct 20, 2012 | Cars & Trucks

2 Answers

HI my 94 mazda protege was running fine untill 2 days ago,when I started it in the morning after few minutes on the road(warmed up) it started hesitating and sputtering when accelerating. noticed when...


when my cars do this I check the fuel supply first.....should be a small filter near the throttle body somewhere that could be prob. then check electric/fuel related items. there are several different items with these symptons, nearly always related to fuel....go to a good websight like autozone repair guide for help....also a haynes or chilton manual available at parts houses will save you lots of bucks----i never take my cars to a garage...this is general info, but i hope it has helped...

Feb 27, 2010 | 1994 Mazda Protege

1 Answer

Stalls upon acceleration and back fires during engine speed.


check your fuel presher . mazda have a high fuel presher,

Apr 20, 2009 | Mazda B2200 Cars & Trucks

2 Answers

94 mazda protege


try buying new points (yes there called points) gap them then install them, they go under the distributor cap, by the condenser, also, the sparkplug wires go in a certin order so if your not sure call an michanics shop and tell them what kind of car you have and they'll tell you what order they should go in. also did you gap the spark plugs??

Sep 22, 2008 | 1994 Mazda Protege

Not finding what you are looking for?
1994 Mazda Protege Logo

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...