Question about 1997 Jeep Wrangler
Posted by Anonymous on
Your forward clutch is slipping, it wont do that for long before you cant move at all,
change your fluid and filter, and add lucas to the trans when you do, if you still have a problem, its over, you need it rebuilt
Posted on Mar 29, 2015
Slip is doom.
Posted on Mar 29, 2015
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
you will need a t-20 or t-15 torx bit driver to remove 2 screws holding the handle this is all that holds them on, on once you have a replacement handle it is easier to remove 2 lower screws on the door panel and unsnap the door panel to loosen it this will allow space making it easier to reinstall new handle just slide each end into the slot and reinsert 2 screws to not fully tighten until door panel is snapped back in. the panel is held on with clips and can be released using plastic pry tool around door panel edges.
Posted on Nov 28, 2008
SOURCE: jeep wrangler bucking
how long has this been happing..one tank of fuel or more, could have been bad gas, replace filter,, put gas dryier in fuel tank..if it continues could possibly be transmission related..the reving down doesn't sound like transmission though if tansmission was slipping it would rev up..good luck
Posted on Jun 02, 2009
Instructions can be found in any basic manual but the simple version is to remove anything obvious that will be in your way (starter, trans lines etc). Disconnect both engine mounts and raise engine to get better clearance (watch stuff on top so you don't break anything) I usually stuff a couple of 2x4 wood blocks between engine & mounts to support it. Remove all pan bolts and take it down (remember pump pickup will interfere) Do what you need to do, then reverse process.
Posted on Jun 12, 2009
The check gauges light is normal because at 400 rpm it isn't running fast enough to build sufficient oil pressure. I am guessing maybe a vaccum leak???
Posted on Jul 10, 2009
Tips for a great answer:
Jan 16, 2012 | 1998 Jeep Wrangler
on Jun 13, 2008 | 2007 Jeep Wrangler Unlimited Rubicon 2...
Dec 08, 2011 | 1997 Jeep Tj
Aug 16, 2011 | 1989 Jeep Wrangler
May 13, 2010 | 1997 Jeep Wrangler
Nov 05, 2009 | 2005 Jeep Wrangler
Jun 02, 2009 | 1997 Jeep Wrangler
Apr 25, 2009 | 1997 Jeep Wrangler
114 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: