Question about Volvo S60

Open Question

Key will not turn to the third position to start car.

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where's fuse for security system in 2003. Pontiac grand am


Is your security light blinking , if so the car won't start . If this is what your car is doing you need to maintain good charge to battery . Put key in ignition then turn to run position , not the crank position leave for ten minutes then turn key off and do the same thing two more times . It takes 30 minutes to reset security , after the third time turn key off take key out . Then put key back in ignition and if you followed everything I said it should reset the security. If you have any questions call me at 270-556-7357
im an auto technician

Mar 28, 2015 | 2003 Pontiac Grand Am

3 Answers

My car wont start ,how do I reset the theft system on a 1999 monte carlo


Is the theft light on the dash lit ? If so turn the key onto the run position till the theft light goes out, about 10min. Turn key off for a few min. then start , hope that helps. If not have to have it checked for codes in the (BCM) body control module or the (PCM) powertrain control module !

Dec 21, 2014 | 1999 Chevrolet Monte Carlo

1 Answer

What fuse go to the theft system on a 2005 chevy


Theft light on car won't start , hook a battery charger up to your car to maintain a good charge . Then turn ignition to on position , do not crank it over leave in that position for ten minutes then turn to off and repeat this cycle two more times .
After the third time turn to off and remove key from ignition then ,
reinstall key and try to start vehicle if it works you just relearned your key to the anti theft system and you gain a free lesson !!!

Sep 24, 2014 | 2005 Chevrolet Impala

1 Answer

My 2004 expedition will start it just takes 2-3 time turning the key, holding each time for a second or two?


try this turn key on but not to start position a couple times on third time try to start. if starts up your fuel pressure is droping off after shut down . ie fuel pressure regulater , leaking injector, fuel pump check valve ect

Aug 03, 2014 | Cars & Trucks

2 Answers

Reset 03 monte carlo anti theift


leave the key in the on position for 10 min and then shut it off this will get the security light off

May 13, 2014 | 2001 Kia Sportage

1 Answer

My 97 geo prism starts when you put the car to ignite but after that it won't stay running what could it be


First turn of the key energize the car electrical circuits for some circuits radio ets. 2nd turn of the key energize the the starting cycle, when you turn the key to the third spring loaded start mode it completes the circuit to the starter solenoid which engages the starter and start the car, the spring in ignition return the key to ignition on.
Maybe you have a malfunction in the ignition on position. Dont have a large bunch of keys hanging in your ignition, it sings back and forth when the car is in the start mode and cause havoc to your ignition switch.

Jan 12, 2014 | Cars & Trucks

1 Answer

My renault clio doesnt start but turns over and then i leave the ignition on and take a relay out and knock it a few times out it back then it starts.this happenes everyday.


wiring connector going to injection unit on right side of engine disconnect it clean terminals with screwdriver and sand paper wet and dry preferabely once this is done spray connectors ,reconnect it and joddle the all other electrical connections on engine spray all with wd40 once this is done the car will start you could try starting car after each connection worked on common fault on these cars also if its a immobiliser fault reset sequence as follows remove key from ign lock up car holding key in locked position count to 30 seconds then unlock car,put key in the ignition to third position( ie key position before starter is engaged) wait 20 seconds then remove key reinsert and car will start if not go through sequence again

Mar 20, 2013 | 2002 Renault Clio

1 Answer

DISARM THE ALARM ON 1998 CAMARO Z28


youv'e engaged the security check security fuses to disarm you'll need to go to your gm dealer to reset they have several proceedures usually with key in on position for three sets of ten minutes after each 10 minutes turn key off count to five turn key back on without cranking the engine do the three times after the third time turn off key count then try to start it should work

Jul 04, 2012 | Cars & Trucks

1 Answer

How do I reprogam keys for my 03 Buick Rondezvous. We lost a key a few years ago and last year bought a new key (to have a spare). The car dealership had said that I needed to bring both keys &...


Insert key and turn ignition to on position. Wait untill the "security" light goes out (about ten minutes). Turn key off. do not remove. repeat this step two more times. After third time remove key. You should now be able to start vehicle. To program the spare use the already programed key and turn it to the on possition (dont start) then off. remove key and insert spare and turn to the on position. Wait for "security light to go out then turn key off. Both keys should now be programmed.

Sep 14, 2010 | 2003 Buick Rendezvous

1 Answer

Starter will not engage anti theft light is on it is a 2005 cobalt


I found this on a website try this

1. Put the newly cut Master key into the keyway and turn it to the ON (RUN) position. A "security" indicator
light on the dashboard will stay on for 10 minutes.
2. Within 1 minute after the indicator light goes off, turn the ignition to "OFF", then return to the ON (RUN)
position. The indicator light again will stay on for 10 minutes (Do not remove the key.)
3. Again, within 1 minute after the indicator light goes off, turn the ignition to "OFF", then return to the ON
(RUN) position. The indicator light again will stay on for 10 minutes. (Do not remove the key.)
4. When the light goes off the third time, the new key is programmed into the computer and will start
the car. Remove the key and then re-insert it into the ignition lock and start the car.
All previously stored codes will be erased. To stop the process at any time, simply remove the key and use
an existing key to start the car.

Mar 25, 2009 | 2007 Chevrolet Cobalt Coupe

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...