Doubtful. The front end geometry of these trucks changed with the model change in 1995, particularly with the FWD models.
Testimonial: "I called the parts store and that told me the two have same parts number to repair them and it should work so thanks for reply"
SOURCE: fuel pump
Fuel Pump on this Vehicle is on the inside of the gas tank it is a not so hard job to do if you have done quite a bit of mechanical work, but if not you best get someone who does have the experience since we are talking with dealing directly with the tank that even when empty it can explode with a spark from a tool striking ant metal.
But if You are that person that knows how to tinker with automobiles I Strongly suggest to go to your local auto parts store and get the book in order to follow the instructions safely, trust me I have done 2 chevy astros and a thunderbird. Good Luck.
SOURCE: 95 gmc jimmy engine codes
9141 does not exist I will assume it is DTC P0141 HO2S Heater Performance Bank 1 Sensor 2
The VCM has the capability to monitor this process by using the Heated
Oxygen Sensor (HO2S Bank 1, Sensor 2). The HO2S (Bank 1, Sensor 2), located
in the exhaust stream before the catalytic converter, produces an output signal
which indicates the storage capacity of the catalyst; this in turn indicates
the catalysts ability to convert the exhaust emissions effectively. If the
catalyst is functioning properly, the HO2S signal will be far less active
than the signal produced by the Heated Oxygen Sensor (Bank 1, Sensor 1).
When the HO2S temperature measures below 360°C (600°F), the
sensor will not produce any voltage and will behave like an open circuit.
This will result in an Open Loop operation.
The HO2S heater provides for a faster sensor warm-up which allows the
sensor to become active in a shorter period of time and remain active during
long extended idle. The DTC P0141 determines if the HO2S is functioning properly
by checking the response time of the sensor. This DTC is a type B DTC.
SOURCE: remove steering wheel on 95 gmc jimmy
u will need a steering wheel puller,u will have to disharm and take airbag off if equip.,i would suggest to get manual it explains step by step procedure!
SOURCE: what is the firing order for an 89 gmc s15 2.8
Hello cman0906: My name is Roger and I will answer your question. The fire order is 1 5 6 4 3 2. See picture. Please rate the answer you recieved. This way we know your answer was correct. Should you need further halp please just ask. Thank You for using Fix Ya. Roger
83 views
Usually answered in minutes!
×