Question about Dodge Ram
Posted by Anonymous on
It could be overdrive solenoid or the button is set to trailer towing mode
Posted on Mar 30, 2015
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
had the same problem except cruse control wouldn't work either. after checking all the relays and fuses the problem turned out to be moisture in the ECM plugs.
Posted on Jan 11, 2009
you could need a throttle linkage adjustment. first check to see if your ram will start in "park" and "neutral" only. if it starts in any other gear=faulty neutral safety switch. replace. ok, now check linkage for proper adjustment...with engine off and in park...remove intake housing..disconnect cableend from attatchment stud on your throttle body..slide cable off the stud (carefully)..verify that the transmissionthrottle lever is fully forward (idle) position..and verify that the lever on the throttle body is at curb idle pos..insert small screwdriver under edge of the retaining clip and remove..center the cable end on attatchment stud to within 0.04", or 1mm. install retaining clip onto cable housing..check cable adjustment..be sure trans throttle lever and throttlr body lever move in sync with each other.
Posted on Feb 13, 2009
Governor pressure sensor or solenoid is going bad. To replace them drop the tranny pan, remove the filter , and the parts are pretty ez to get to. These aren't cheep thou, but replace them as a set. Parts will probly run about $200.
Posted on Feb 20, 2009
Tips for a great answer:
Apr 24, 2016 | 2007 Dodge Ram Truck
Mar 28, 2014 | 1999 Dodge Ram
Sep 10, 2010 | 2001 Dodge Ram 2500 Truck
May 17, 2010 | 2001 Dodge Ram 1500 Truck 2WD
Jan 11, 2010 | 1997 Dodge Ram 1500 Club Cab
Jan 19, 2009 | 1999 Dodge Ram
70 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: