Question about Volkswagen Jetta
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
VW didn't put a "dipstick" on the trans for whatever reason. You technically have to use the VW Vag-Com scanner to properly check the trans fluid level as VW says it has to be checked at a specific temperature. But there is a "shade-tree" workaround. Start the car and leave the engine running the throughout the entire procedure. You have to get the trans fluid warm-a little under normal operating temp. 95F-104F is what you want-you can attain this after letting the car idle for 8 or so minutes. Continuing, leave the trans in park, and make sure you are on as level of a surface as possible. Then loosen the allen plug on the bottom of the trans pan. You will then see another plug. Remove this plug. Fluid should just trickle out of the hole if it is at the proper level. If it trickles out, you are good. If it doesn't you need to add fluid. Add VW spec ATF through the fill port.The fill port on the top front of the trans is capped off by a red cap and is very visible. Very carefully pry the cap off and then wiggle the plug out. I'd highly suggest having a spare red cap on hand-VW dealer has them. Then you can pour fluid into the trans. Add a little bit at at time, and all the while watching for the fluid to tricke out of the trans plug hole. When it trickles out, replace the inner plug and then the outer plug. That's it. Recheck after driving the car for a few miles. FYI- A flud and filter swap on the the VW auto trans takes 3 liters, so keep that in perspective. I hope this helps you out.
Posted on Apr 14, 2009
Catalyst System Efficiency Below Threshold Bank 1
P0300=Random/Multiple Cylinder Misfire Detected
P0301=Cylinder 1 Misfire Detected
P0172=System Too Rich Bank 1
P2181=Cooling System Performance
you need to write these down,have someone clear the codes in the car,then go for short ride and recheck which if any code reappears.it's like domino's affect,one sensor can start a chain affect with the others.
Posted on Dec 10, 2009
1.Disconect lower hose from intercooler and oil (from 0,1 liter or more) (sometimes 1-2 liters) comes out, you should not drive it.(car had probably loose power) Change the turbine, oil and oil filter. do not forget to disconect lower hose and let oil drain out. Otherwise when new turbine is instald, the air flow will **** this oil inside the engine and distroy it.
2.your car is not designed to run without turbine and will not work like normal disel.(SDI).
hope it helps
Posted on Apr 06, 2010
Tips for a great answer:
Apr 20, 2016 | Cars & Trucks
Jan 01, 2016 | Cars & Trucks
Dec 21, 2010 | Volkswagen Golf Cars & Trucks
Apr 06, 2010 | 2002 Volkswagen Jetta TDI
Feb 25, 2010 | 2002 Volkswagen Jetta TDI
Mar 22, 2009 | 2002 Volkswagen Jetta TDI
Mar 21, 2009 | 2002 Volkswagen Jetta TDI
Dec 08, 2008 | 2002 Volkswagen Jetta TDI
21 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: