Question about Cars & Trucks

Open Question

Abs light on restraint system defective

Loses power after braking sometimes it doesnt open the turbo

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: ford maverick

i have the same problem. im told its the abs sensor ring. £300 to fix

Posted on Sep 15, 2008

  • 12 Answers

SOURCE: 2002 Suburban ABS System Brake Light

I have had this same problem on two difference vehicles both of which are suburbans.

The solution is simple.
Remove the engine cover.
Locate a small ground wire that is bolted to the top rear of the engine block on the passenger side.
Remove the bolt, clean surfaces and replace.

This should solve your problem.

I know it seems too easy but it works.

Posted on Mar 02, 2009

emissionwiz
  • 75822 Answers

SOURCE: ABS light on after replacing the front and rear brake pads .

u will need to check the wheel speed sensors behind the brake rotors to see if they got damaged or disconnected during the brake job, as long as the ABS light is on the Anti-lock brake system is disabled, regular braking without the need of ABS will feel fine.

Posted on Apr 01, 2009

  • 2 Answers

SOURCE: transmission doesnt shift abs & brake light on speedometer doesnt work

I had the same problem with ABS light and speedometer, I was told that it is the transmission control module. It has not yet stopped shifting but I have had times where it just wont stay running. It will start and then stall. Hope this helps.

Posted on May 24, 2009

  • 1111 Answers

SOURCE: 1996 dodge ram 3500, abs brakes are locking up

is it the front or rear locking up? you really have to have this truck loaded (load valve under bed) before the back brakes come on and i think these are the same as my 1999 2500 where the rear is only abs, and not on the front..dumb design i know, but thats how it is...determining if its rear abs only and which axle is locking up will help pin point the problem...i put 100000 miles on my dodge since i got it in 2001 and i put 8 sets of pads on the front and just changed the rear lining and thats only because the rear wheel cylinder was leaking causing the rear brakes to lock up..

Posted on Jun 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Citroen c5 esp/asr system fault


Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS, TPMS, MIL, CEL and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Anti-lock brake system. TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module. TPMS Tire Pressure Monitor System, MIL Malfunction Indicator Lamp, CEL Check Engine Light.

Nov 09, 2012 | Cars & Trucks

1 Answer

ABS light comes on when stopped and restarted hot


Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS, TPMS and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Anti-lock brake system. TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module. TPMS Tire Pressure Monitor System

Nov 06, 2012 | Cars & Trucks

1 Answer

Restraint system defective visit workshop


Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS, TPMS and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Anti-lock brake system. TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module. TPMS Tire Pressure Monitor System

Nov 02, 2012 | Cars & Trucks

2 Answers

Brake light and atl light stays on


Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS, TPMS and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Anti-lock brake system. TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module. TPMS Tire Pressure Monitor System

Nov 02, 2012 | 2002 Jeep Liberty

1 Answer

Power steering prob.lights come on



Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)


Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module

Oct 18, 2012 | 2006 Hyundai Tucson

1 Answer

Reduce power engine


Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS and BCM faults) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module

Oct 09, 2012 | 2003 Chevrolet Suburban

1 Answer

Abs light on


Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, SRS and BCM faults) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, SRS Supplemental restraint system, BCM Body control module

Oct 08, 2012 | Cars & Trucks

1 Answer

What is the function of ECT in Toyota hi ace 2L turbo diesel?


E electronically C controlled T transmision
  • Sometimes it has two sometimes three settings....
  • Power which holds the gears longer before change up....
  • Economy....gears change normally....
  • Snow....traction control...This last mode uses the ABS
  • A anti lock B brake S system
  • The ABS system automatically monitors the rotational speed of each wheel, and when brakes are applied, releases any brake about to lock up, independent of the others.
  • This is done because when wheels lock and skid, traction and control is lost....
  • Traction control brakes any wheel which begins to lose traction under power, spinning too fast and thereby also loosing traction if it was not controlled...
Hope this answers your question
It can be a slippery subject but we can slide across it....In a controlled way naturally
Best regards Johngee10

Oct 31, 2010 | 1991 Toyota Camry

1 Answer

About a week ago, having switched on and set off, all the brake warning lights stayed on, that is the ABS, TCS, TCS OFF and Brake System Warning lights. The brakes continued to work OK with no extra travel...


abs=anti-lock brake system/ tcs=traction control system ==sounds like you have a problem with ur abs possible bad sensor or a wiring connection problem when abs shuts down [trouble light] your brakes will work normal but if u stomp or brake hard the brakes will lock up skid and the tcs doesnt affect brakes but if u accelerate hard tires will spin lose traction check the wiring and connections to the sensors sometimes debris hits the wire and loosens the connection if looks ok and light is on have car scanned for the trouble code most auto stores such as auto zone/advanced auto offer this service for free the code will what and where the problem is so repair can be made

Jul 18, 2010 | 2000 Mazda 626

1 Answer

My brakes lose power system intermittently


It's quite possible you may need to check out your ABS system. Certain GM light trucks of that year, and a few in subsequent years had issues with the EBCM (electronic brake control module) These units are mounted on top of the ABS valve body, under the vehicle, on the left frame rail (all the brake tubing is attached). Sometimes the faulty unit would cause the electric ABS motor to continue running even after ignition shut down. Sometimes they would cause erratic ABS actuation.The other thing may be a faulty vacuum check valve at the brake booster. If that valve goes bad, your brake pedal will be really high and hard to depress. On some 1/2 ton GM trucks with vacuum assist power brakes, there is an electronic sensor that measure vacuum to the booster. In those instances typically a warning message will come across the drivers info center on the instrument panel. I hope this info can help.

Nov 14, 2008 | 1999 Chevrolet Silverado 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...