Question about 2004 GMC Yukon

1 Answer

2004 gmc yukon door ajar light on dash but door is not ajar

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • GMC Master
  • 21,873 Answers

The typical cause is a failed sensor in one of the door latches.

Posted on Mar 27, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 51 Answers

SOURCE: 2003 ford expedition "door ajar" & interior lights staying on

the wire on the door latch make sure they are plugged in or unplug it and the light should go out if it does not then it's not that door

Posted on Feb 16, 2009

chuck943
  • 783 Answers

SOURCE: 1997 ford exibition xlt my interior light and running board lights wont go off along wiith the door ajar light on dash board. please help

Take some WD40 and open the doors and spray a liberal amount into each of the door latches. Then open and close the doors firmly several times. This will work most of the time to unstick the ajar switches.

Posted on May 24, 2009

  • 1 Answer

SOURCE: door ajar light won't go off

I had the same problem. Spray WD-40 (with the sprayer extender) into the latch of the doors very liberally. Open and close doors a few times. Should resolve issue.

Posted on Jun 01, 2009

  • 5 Answers

SOURCE: 2004 Yukon liftgate fuse error code

Replace the ECC 10ma fuse on the driver's side fuse panel.
This happens to me periodically.

Posted on Aug 30, 2009

MNfisherman
  • 11896 Answers

SOURCE: door ajar dash trouble and dome light stays on even if all doors

The door sensors will need to be replaced. A screws can be removed and then a wire can be taken of and you then can replace the switch.

Posted on Sep 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Door chime while am driving need to get bitb to stop 04 gmc yukon denali


Most likely a "door ajar" switch. Basically a little button that gets pushed when you close the door. If it's broken, your truck might think the door is open all the time.

Sep 21, 2015 | GMC Cars & Trucks

1 Answer

Yukon dash lights stays on and radio stays on vechile won't start have new battery


does the engine turn over? have you checked the starter motor?

Mar 18, 2014 | Cars & Trucks

1 Answer

Door ajar light on and doors all closed then interior lights flashing on and off and then factory alarm going on and off


same thing happened to me. also interior light stayed on and power locks wouldnt work. It was our door latch assembly in drivers side door. part is $110 - $250 depending on where u get it

Mar 09, 2014 | 2006 GMC Yukon

1 Answer

2004 Yukon, air whether it's AC, heat or just vent doesn't go where the mode says it should. Mostly comes out the defrost ports on the dash. This is for both the driver, passenger and rear seat controls.


This is probably due to a faulty blend door or blend door actuator. The blend door is a device inside the dash that directs the air flow to the desired vent. Sometimes they will fail, but usually is an actuator. Unfortunately, you will have to remove the dash to see if this is the problem. If you have never removed the dash on a Yukon, you are in for a very big job. Here is also some good information

Oct 15, 2010 | 2004 GMC Yukon

1 Answer

Warning "right rear door ajar


the switch has gone bad in the one of the rear doors. The truck thinks it has a door open, which you know it doesn't.

Jul 01, 2009 | 2000 GMC Savana

1 Answer

2004 GMC Yukon won't start/shift ind. on dash won't illuminate


yes! its possible bad connection or the neutral safety switch is bad.hope this helps !!

Mar 27, 2009 | 2004 GMC Yukon

1 Answer

2003 yukon , left rear door ajar shows on dash


You have a problem with the door ajar switch being shorted, or not closing. Some are in the latch assembly, and some are in the door.

Mar 07, 2009 | 2003 GMC Yukon XL

1 Answer

Door ajar warning light will not go off ...


One of the door ajar switchs in your dooors has failed.

Oct 10, 2008 | 2004 GMC Canyon

4 Answers

Location of fuse box/panel for 2004 yukon denali xl


There are 2 fuse panels in the Denali.
One is a panel on the drivers side, its on the dash but facing the door.

The ohter is under the dash and above the pedals, this one is much tougher to access.

Your Owner's Manual should tell you where the fuses are that you need to access.

Jun 15, 2008 | 2004 GMC Yukon

Not finding what you are looking for?
2004 GMC Yukon Logo

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...