Question about Chrysler PT Cruiser
If you mean the oil pressure warning light, it could be the pressure switch, or the engine could have low oil pressure.
Posted on Mar 27, 2015
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
This is the pressure light, nothing to do with the oil needing to be being changed, you have low oil pressure being indicated, this will destroy the engine if the light is really indicating low oil pressure, have the oil pressure tested with a mechanical test guage at a shop, if the oil pressure is ok then replace the oil pressure light sending unit.
Posted on Nov 23, 2008
Go to the following website for directions on removing and installing the Oil Pressure Sender:
Hope you find what you are your looking for! Good Luck!
If you have any more problems let me know.
Thank you for using Fix Ya!
Don't forget to rate the overall satisfaction of this answer!
Posted on Jan 31, 2009
Yes, the tumbler is worn, possibly from a heavy key chain or abnormally frequent stop/starts. Ther amy also be a bad connection in the switch connections itself, that may not require a whole new ignition switch.
Posted on Feb 14, 2010
SOURCE: pt wont start or turn over
I have a 2005 pt cruser ,have puled stater off, took to parts store had it tested, tested good, took battery in replaced with new one. cleaned all terminals, stick key in ignition,can,t get starter to engage I have all dash lights, windows, headlights,fanmotors, door locks, could this be key switch promblems???
Posted on Jun 25, 2010
SOURCE: Where is crank sensor on
REMOVAL - 2.0, 2.4, 2.4L TURBO
The Crankshaft Position Sensor is in the front of the engine block just under the starter motor (CRANKSHAFT POSITION SENSOR LOCATION).
Disconnect the negative battery cable.
Raise vehicle and support.
On 2.4L SRT-4 remove the lower inner cooler hose from the metal tube.
Remove the Structural Collar (Structural Collar and Bending Strut-(Automatic Transaxle Equipped) ), refer to the Engine, Structural Collar Removal and Installation section.
Unlock and disconnect the electrical connector to the crankshaft position sensor.
Remove the crankshaft position sensor bolt.
Remove the sensor. Arrow points to sensor in picture.
Posted on Aug 22, 2011
Tips for a great answer:
Feb 23, 2013 | 2005 Chrysler PT Cruiser
Jun 28, 2011 | 2002 Chrysler PT Cruiser
May 22, 2011 | 2002 Chrysler PT Cruiser
Apr 18, 2010 | 2005 Chrysler PT Cruiser
Mar 10, 2010 | 2005 Chrysler PT Cruiser
Jan 07, 2010 | 2002 Chrysler PT Cruiser
Sep 25, 2009 | 2004 Chrysler PT Cruiser
Nov 05, 2008 | 2004 Chrysler PT Cruiser
32 people viewed this question
Usually answered in minutes!