2006 Nissan Sentra Derek's . Engine stops when you step on brakes.
SOURCE: 2006 nissan sentra trunk doorrreplacement
all you have to do is inspect the old trunk door how it is attached to the hinges.
be careful on the tension bars that are lifting the trunk. once you released them, the trunk would just fall down.
there are two of these tension bars, they are like springs to help you lift the trunk and they are very tricky to remove and install
after you have done that then it just a matter of removing 2 bolts on each side of the hinge and remove the trunk.
if you have electrical accessories attached to the trunk such as solenoids or trunk cables, remove them first.
then do the reverse on installation.
you may want somebody helping you hold to the trunk before you remove the bolts. they are heavy.
tnx 4 using fixya,
drcool
SOURCE: 1997 Nissan Sentra, weird humming/buzzing sounds
can you hear this through the stereo? If so you may have a problem created somewhere in your ignition , where the stereo is picking up a fluctuating signal.
SOURCE: Step by step on how to replace front wheel bearing
Raise vehicle, remove wheel, remove brake caliper, remove brake rotor remove steering knuckle by disconnecting the tie rod, ball joint, and strut. press out hub, remove snap rings press out bearing. Reassemble in reverse order.
SOURCE: changing the serpentine belt on an '02 nissan sentra
usually with a serpentine belt the trick is the tensioner. You need to be able to move it to release and replace the belt. the only other thing is the routing of the belt. several special tools are sold to move the tensioner. some are long bars with different types of attachments and some a ratcheting bars with the same attachments. Sometimes you can do it with a standard retchet but not always. Wish i could be of more help maybe you have a harbor freight in your area and they sell an inexpensive one you can use. good luck
70 views
Usually answered in minutes!
×