Http://www.rockauto.com/ and search Buick>2002>Century>3.1>Motor Mounts
There are 2 types of engine mounts. The first one rockauto has listed is the easier to change; they are staring you in the face when you open the hood. To change, you'll need a 15mm socket, a ratchet (extensions are good too) and a 15mm wrech. 4 bolts hold the bracket to above the radiator and then 1 bolt goes through the rubber portion. Remove and replace.
The other mount is a little bit more tricky as it is under the oil pan and above the subframe behind the passenger front tire. This can be replaced by dropping the subframe and supporting the engine or hoisting the engine at a slight angle. IIRC those are 15mm as well but might be 17mm.
SOURCE: Orifice Tube - 2002 Buick Century
Some are in the inlet to the evaporator and some could be in the condenser line. You can get a new orifice tube on autozone for $5 - 20
http://www.autozone.com/N,16301861/shopping/partTypeResultSet.htm
SOURCE: how to replace a coolant level sensor, 2000 buick century
The coolant level sensor is located on the radiator. If you are looking at the engine from the front of the car it will be on the left side. There will some kind of clip holding it in the radiator. Removed the clip and pull the sensor out. You will lose coolant so try to swap it out quick or drain some of the coolant out. Once new sensor is installed, install clip to keep the sensor in place and reconnect the wires to the sensor. Crank the engine and make sure the coolant level is full. This should correct your problem.
SOURCE: How do I replace broken 2002 buick century passenger side mirror?
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door
SOURCE: 1991 Century Buick V6 starter replacement.
remove the positive battery cable from the post
remove the 3 wires from the starter and the two bolts holding the starter to the block.
reverse the procedure for installation.
Testimonial: "I know that there is usually only 2 bolts to remove a starter. I've identified one bolt but was not sure about the location of the other one. Thanks"
1,295 views
Usually answered in minutes!
×