1994 Chevrolet Corsica Logo

Related Topics:

Sean layton Posted on Mar 14, 2015

I have took all the spark plug wires off of my Corsica 1994 3.1 v6 and I don't know how to get them back on properly can you tell me how

5 Related Answers

Jonah Oneal

  • 14092 Answers
  • Posted on Mar 22, 2009

SOURCE: 1999 oldsmobile alero v6 spark plug wire repalcement

raise your hood the 3.1 engine. from front left ccylinders is 246 and the back left is 135. go to coil pack . as you look down at the coil pack .start from the left .523641. 5 goes to cylinder 5 .2 goes to cylinder2 .3goes to cylinder3 so on .the 523641 that where your wires from coil pack to that cylinder will go.

Ad
emissionwiz

Marvin

  • 85242 Answers
  • Posted on Mar 23, 2009

SOURCE: 2001 Pontiac Grand Am Spark plug wire matchup.

here u go.
5528c01.gif

Anonymous

  • 1489 Answers
  • Posted on Apr 29, 2009

SOURCE: Will These Spark Plug Wires Work for My Audi?

No. I would go with the cheaper set.

Anonymous

  • 158 Answers
  • Posted on Aug 30, 2009

SOURCE: spark plug wiring diagram for gm 3.4 liter v6

http://autorepair.about.com/od/enginefiringorders1/Engine_Firing_Orders.htm

Anonymous

  • 3640 Answers
  • Posted on Aug 31, 2010

SOURCE: Need to know the placement spark plug wires 2001 chevrolet malibu

do not have a diagram, but heres the firing order. 1-2-3-4-5-6, 1-3-5 is in back, # 1 is closest to alternator. from left to right, or facing engine from front 2-4-6 is in front. 5-2-3-6-4-1 is coil pack, from left to right (facing from front of engine).

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
3answers

I need to know the ignition firing order for 1993 chevy corsica 3.1 multiport FI 6 cylinder engine automatic transmission

you can get guide from many sites.. i know few
error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single thing is covered
within seconds u can get the access and it's totally illustrative complete
1helpful
1answer

I have 88 chevrolet corsica. No spark at the plug wire put new coils / module on still no spark can the crankshaft position sensor stop it from getting spark and i checked all te fuses Bill

Yes the cam sensor could fail to send a signal to the ignition module, but a V6 engine does not use a cam sensor.
It does use a crank sensor.
You would need to know that the ignition module and coils have battery voltage, then you would need a book to give you the test procedures for the computer and crank sensor.
0helpful
1answer

I have a 91 V6 Corsica that I have recently changed the plugs,wires , fuel filter and removed the CC. My problem is that my engine sounds like it's misfiring while under load. I can throttle it fine in...

you don`t say if this was the reason that you changed the parts in the first place.if it was running okay before you did the work then something you did during the job wasn`t done correctly,(plug wires not on the proper plug or wire not on properly)when not in gear there is no load on the motor so it won`t act up as much(it does miss not noticeable) as when in gear when there is a load on the motor.also believe it or not if the fuel filter was not installed in the proper direction it can disrupt fuel flow(they have and arrow on then to indicate flow direction.
0helpful
1answer

1994 GMC Sierra Pick 4.3 V6 is jerking while driving and tac is bouncing

This is usually caused by a spark plug not sparking. It could be a spark plug, a spark plug wire, or low compression on 1 cylinder. Your check engine light should be on. You can take it to Autozone and have them put it on their scanner and the diagnostic printout will tell you where the mis-fire is at. You can also usually see spark at night time with the hood open in the dark, if it is a spark plug wire.
2helpful
1answer

What is the order of the spark plug wires for my 1994 isuzu?

For the 1994 Isuzu Trooper 3.2L DOHC V6:
Cylinders:
.......(back).......
|..5.............6..|
|..3.............4..|
|..1.............2..|
.......(front).......
Coil Connections:
............(back)...........
|.1..4.|..|.6..3.|..|.2..5.|
............(front)............

Let me know if this helped....Thanks for using FixYa.com!
0helpful
1answer

1990 chevy corsica 3.1 liter v6 engine. started ran fine went shopping and on my way home it dies out of no where, start it back up give it gas dies again. it will run in idle but sounds rough and as soon...

Coils and wires are the most likely culprits as they never get replaced hardly ever. You cant really test a coil, you can check for resistance on the plug wires but that doesnt tell you if the insulation is bad on them.
0helpful
4answers

Firing order

for an L4 2.2l

e8f5cff.gif
for a v6

89f08ed.gif
0helpful
1answer

Spark plug wiring pattern for 94 sunbird

Hi,

Depends on what engine is there inside.
1. for the 2.0 4 cylinders, 1-3-4-2;
2. for the 3.4 V6, 1-2-3-4-5-6

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.
Not finding what you are looking for?

123 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...