Shifting rough, as in, when you put it in reverse or drive it hits hard? Shutters? Slips? Time for a rebuild or get a good replacement.
When I put it in gear than first to second but than runs good except twice now I lost power but truck stayed running wasn't out gear felt like it wasn't getting fuel
When I put it in gear than first to second but than runs good except twice now I lost power but truck stayed running wasn't out gear felt like it wasn't getting fuel, NO slipping of transmission tho just hits hard
Always start with the cheap stuff. Replace the fuel filter and remove the air filter. See what happens. Beig an 86, you could have a vacuum modulator on the back end of the transmission. On the passenger side. Only thing back there that has a hose going to it. If the hose is bad or the modulator is bad, this can cause hard shifts( high RPM's). Something to look at.
×
SOURCE: 1986 ford f350 shifting problem
hello you can check the slavecylinder for leakage there is a reservoir up near your mastercylinder black mounted on firewall has a plastic line take the cap of fill with fluid if low try again if no go check fluid level in transfer case with bent coat hanger or wire should register at leat 2-3 inches down if all is good sync gears out of sync goodluck
SOURCE: Auto Trans shifts from 1st into OD then engine runs rough
need more info need to scan and post the codes pulled
SOURCE: 99 ford taurus 3.0 dohc tranny shifts rough out of
try having the VSS (vehicle speed sensor ) replaced, this is where all the data for the powertrain control module (PCM), made mine shife perfect and made the speedo and cruise work better too
http://technoanswers.blogspot.in/2012/02/nissan-pathfinder-stalls-and-bucks-on.html
-----------
Nissan Pathfinder Backfires?
http://technoanswers.blogspot.in/2012/02/nissan-pathfinder-backfires.html
---------How to adjust rpm?
http://schematicsdiagram.blogspot.com/2011/12/how-to-adjust-rpm-on-2009-dodge-charger.html
------------Engine cuts out at 3000
RPM?
http://schematicsdiagram.blogspot.com/2011/12/engine-cuts-out-at-3000-rpm.html
----------This will help.Thanks.
83 views
Usually answered in minutes!
×