I just found my sticker on line last night for my 75 GMC. Go to : www.gspp.com Thats Golden State Parts and they have pic's of all the decals they sale and you can get all the info you need. By the way your 250 inline 6 was used in the 75 truck also 2 bll barb, so that sticker will work for you. It has complete instructions for tune up and spec's.
Hope this helps Mike
SOURCE: replace serpentine belt
i have a 97 sunfire with a 2.2 and a/c my sticker is intact would you like a pic?
SOURCE: need picture diagram of vacuum hoses for 1987 chevy s-10 blazer
try this website to see if they have your car listed its www.autozone.com if you are not able to get it try your local library or local chevrolet dealership in the parts department
SOURCE: where are the sparkplugs located on a 4.2 inline 6
Under the top of the engine there is a cover. Remove this plastic cover and under you will find an individual coil on each cylinder held in place by a bolt. Unplug the coil, remove the bolt that holds the coil in place and twist apull up gently to remove the coil boot. Under the coil is the plug. Use platinum plugs that are rated for about 80k miles so you don't have to do this procedure but once every few years. Hope this helps, good luck
SOURCE: i need the serpentine belt diagram for a 96
Below is the diagram for your '96 Mustang with a 3.8 V6. Best of luck with your repair and please return to rate this solution. Thank you and thanks for using Fixya!
Greg
SOURCE: vacuum diagram for 78 chevy
1978 Chevrolet Truck C10 1/2 ton P/U 2WD 4.1L 1BL 6cyl
Fig. 14: Vacuum hose schematic - 1978 250 engine, light duty emissions (except California)
Fig. 15: Vacuum hose schematic - 1978 250 engine, light duty emissions (California)
Hope helps (remember to rate this answer).
260 views
Usually answered in minutes!
×