What would cause both side mirrors not to adjust when in reverse on a 2008 Acura MDX? both mirrors adjust just fine if you move them with the switch in the door but do not lower automatically when or on reverse. Also, where is the relay (I'm assuming) located?

SOURCE: remote garage door opener

1-800-355-3515
www.homelink.com

1. Position vehicle within 10 feet of garage door- engine off and battery on.

2. Press/hold 2 outside buttons of Homelink transceiver until red indicator starts flashing rapidly, then release button. This should take about 20 seconds. This erases any previously learned codes.

3. Press/hold remote control and press/hold button of Homelink transceiver simultaneously. Slowly move remote control from 5" away to 1" away from Homelink transceiver. Release both buttons after red indicator starts blinking rapidly. This should take about 5 seconds. I discovered that the Homelink in my TL is a bit faulty because it took much longer to accomplish this than when programming the Homelink in my MDX. My TL's Homelink may "unlearn" it's code in the future and the needed proximity of the TL to the garage door may be much closer than desired until I get the Homelink fixed.

4. Press training button on garage door opener unit until the indicator lights illuminates- this should be immediate.

5. Within 30 seconds press/hold the Homelink button for 2-3 seconds until the red indicator starts flashing rapidly. Repeat a second time. It should now be programmed. Check it by pressing the programmed button on the Homelink receiver.

6. When programming more than 1 garage door opener unit, disconnect power from unit before programming more units. By not doing this the programmed unit could conflict with the unprogrammed units commands.

Problems:

1. The Battery in the garage door remote may be too weak to program Homelink. However, the battery may be strong enough to operate the garage door. One of my remote controls had a weak battery- my system was installed today, fresh out of the box. I had to use the second remote control for the programming of Homelink on my 2 vehicles.

2. Antenna on the garage door opener unit must be hanging down, fully extended.

SOURCE: 2004 Acura MDX Water Leak

The 2002 MDX I worked on turned out to be a drainage problem . Seems the factory installed foam in the bottom of the hinge pillar post which blocked the drain holes . Take off the mud flap , remove enough of the splash shield to access the bottom of the hinge pillar and drill a half inch hole at the front lower corner aiming the drill slightly upward ( be sure to protect the bare metal) .Water gushed out when I did this. For extra ins. remove the kick panels and check for two holes a few inchs from the floor, plug and chaulk these holes. Hope this worksfor you too