Firing order 2007 Mitsubishi endeavor 3 spark plugs

The 4G64 (2.4L) engine is an in-line four cylinder engine. The cylinder numbers are assigned as 1-2-3-4 from the front of the engine (timing belt side). This engine is fired in the order of the 1, 3, 4 and 2 cylinders.
Feb. 27, 2009

Spark Plug Order ' Mitsubishi Eclipse 3G Club

Pictures

https://www.google.com/search?q=firing+order+for+2007+Mitsubishi+Eclipse+Spyder+2.4L

Strictly speaking you have two fuel / air sensors in the manifold for the catalytic converter and two O2 sensors after the cat.

Details here

https://www.google.com/search?q=2007+Mitsubishi+Eclipse+Spyder+2.4L+Replace+o2+sensor

buy original equipment manufacturer sensors (OEM). Their job is important to engine management.
..

1 3 4 2

Here it is.

YOU NEED LONG SPARK PLUG SOCKET. NEED A 3/8 INCH RATCHET WRENCH.YOU NEED EXTENSION.YOU NEED SPARK GAUGE YOU NEED A TORQUE WRENCH. NOT MANDATORY JUST DONT OVER TIGHTEN SPARK PLUGS STRIP ALUMINUM THREADS WAIT UNTIL ENGINE COOL TO KEEP FROM WARPING THE HEADS. SPARK PLUGS LOCATION ON TOP OF CYLINDER HEADS.TO GET TO SPARK PLUGS THE COILS ON TOP EACH SPARK PLUG.HAS TO BE REMOVED BY REMOVING SMALL SCREW.THAT HOLD COILS DOWN.AND CHANGE ONE SPARK PLUG AT A TIME SO YOU WONT GET THEM MIXED UP.GAP PLUGS AT 0.028 - 0.031

Fig. 3.0L Engine Firing order: 1-2-3-4-5-6 Distributorless ignition system

Fig. 3.5L Engine Firing order: 1-2-3-4-5-6 Distributorless ignition system

Fig. 3.0L Engines without DIS Firing order: 1-2-3-4-5-6 Distributor rotation: Counterclockwise

Fig. 3.0L Engines with DIS Firing order: 1-2-3-4-5-6 Distributorless ignition system

Fig. 3.5L Engine Firing order: 1-2-3-4-5-6 Distributorless ignition system

Fig. 3.0L Engine Firing order: 1-2-3-4-5-6 Distributorless ignition system

Fig. 3.5L and 3.8L Engines Firing order: 1-2-3-4-5-6 Distributorless ignition system
Back to Top

Here is the firing order diagram for your vehicle, and let me know if you require any further assistance.

The firing order is 1-2-3-4-5-6

The rotor spins counter clockwise and bottom of the distributor cap is the number one spark plug lead.

For more details, you can check the information about Mitsubishi Galant/Mirage/Diamante 1990-2000 FIRING ORDERS in Autozone.com (free register).

Hope this helps.

Remove the upper intake manifold. Good luck.

To get to the rear spark plugs you have to remove the intake plentum (Black plactic piece on top of motor)

you have to take the plenum off. the big plastic thing on top of the engine.