Where is the range sensor located on a 2003 honda

The knock sensor on a 2003 Honda CRV is located on the engine block. Specifically, it is located under the intake manifold, which means it can be difficult to access. Here are the steps to locate and replace the knock sensor on a 2003 Honda CRV:

1. Disconnect the negative battery cable to prevent electrical shock.
2. Remove the intake manifold. This involves removing several bolts and electrical connections.
3. Locate the knock sensor, which is located near the rear of the engine block, under the intake manifold.
4. Disconnect the electrical connector from the sensor.
5. Remove the sensor from the engine block. This may require a special tool, depending on the specific design of the sensor.
6. Install the new knock sensor, making sure it is properly aligned and tightened to the correct torque specification.
7. Reconnect the electrical connector to the sensor.
8. Reinstall the intake manifold, making sure all bolts and electrical connections are properly secured.
9. Reconnect the negative battery cable.

Note that if you are not experienced with working on engines or are unsure of how to proceed, it may be best to seek the assistance of a qualified mechanic to replace the knock sensor on your 2003 Honda CRV.

The sensor is usually encased in a pnuematic piston located in the front bumper. You ran over a curb? You hit the bumper, it deployed.

Here is the link to utube videos :

https://www.youtube.com/results?search_query=2007+Honda+Odyssey++Transmission+range+sensor+location

Error Code: P0706
Fault Location:
Transmission Range (TR) Sensor - Range/Performance Problem
Possible Cause:
Malfunction Indicator Lamp (MIL) Triggered on first occurrence.
Wiring open or short to ground.
Transmission range (TR) sensor.

Go to http://www.hondaaccordforum.com/forum/general-tech-help-7/2003-honda-accord-v6-camshaft-position-sensor-location-50640/

There is a photograph of the location. Sorry I could not post the pic here as it is exceeds this site's size limtt.

Speed sensor is on the transmission

http://www.civicforums.com/forums/7-honda-civic-diys-civic-tech-chat/326666-camshaft-position-sensor-location.html

Bank 1 is the O2 sensor on the exhaust manifold just about where the exhaust pipe connects to the exhaust manifold.

If The engine in your van is a 3.5L, the knock sensor is under the upper intake manifold. This has to be removed in order to access the sensor on top of the engine block. The job requires an upper intake gasket set and about 1.5 hours to do; if you are handy with tools. For those who aren't; better off leaving this one to the professionals.