The oil level sensor is on the bottom of the oilpan held on by 3 10mm nuts. The oil pressure switch is on the remote oil filter housing,The oil level sensor is on the bottom of the oilpan held on by 3 10mm nuts. The oil pressure switch is on the remote oil filter housing,
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
https://www.autogenius.info > bmw-3-series-e36-and-e...
May 28, 2018 - BMW 3 Series E36 and E35/5 (1990 - 2000) - fuse box diagram Ā· Front power distribution box Ā· Relay carrier under LH side of dash Ā· Connector strip ...
For the BMW 7 series (E38) 1994, 1995, 1996, 1997, 1998, 1999, 2000, 2001 model year. Fuse box in engine compartment. fuse box location. Open the hood.
see if there is an inline fuse on the power wire to the radio. It appears to be a known issue. Check out the link
Full oil does not mean that you have oil pressure.
The sending unit is located right by the oil filter mount.
It is very possible that you have a bad sending unit, gauge, or actually do have low oil pressure...best to have pressure checked by a good mechanic
1998 bmw 740il
My personal suggestion would be to go for these repair catalogs. I know this website reliable-store that i used to buy them from, and they sold online it was very good manual. Go ahead, I bet.
All BMW V8 motor have leak oil problem on bad gasket in valve cover. When remove plastic cover where is "BMW" in to camshaft &valve cover,its leak visible where is ignition coil on sparkplugs.
check battery cables.make sure they are not loose are or corroded.if battery cables okay.problem could be faulty starter - electronic immobilizer control - ignition switch + check its fuse first.if you disconnect battery cables besure to turn off radio so you wont lose code.
×