Need to clean or change oil pressure sensor switch
First off if the oil warning light is on, u need to check the oil pressure with a gauge with the engine at operating temp. and make sure oil pressure is up to spec. a bad switch can cause it to come on also. on the backside of the engine there is an aluminum heat shield covering the switch held on with 3 15mm bolts. after you remove the shield the switch can be removed with a deep socket. dont over tighten the new one when you put it in.
SOURCE: 2002 chryler sebring is leaking anti freeze
It depends on where the leak is coming from. If the water pump is leaking, it has a hole on the bottom of it. You will see a trail of dried anti freeze coming from the bottom of it, indicating a bad water pump. It's best to dry everything off, crank it up and let it come to operating temp and check for where the leak is coming from. It may just be an old hose or loose clamp.
SOURCE: how can i replace the crankshaft position sensor
Fig. 2: Location of the crankshaft position sensor on 2.4L engines
SOURCE: i need the firing order on a 1999 chrysler sebring
153624 on a six cylinder. This should be in cast on the intake manifold. To locate what tower to use on the cap, do this. pull the #1 plug. Bring it to tdc on the compression stroke. Now chk out where the rotor is pointing and that's the tower for #1. Good Luck -Ned-
SOURCE: can i replace the camshaft sensor on my sebring
the camshaft sensor is not sold separately for a 2.5 engine,it is mounted in the distributor and you would have to replace the whole distributor!
SOURCE: oil sending unit on 2004 chrysler sebring V6
Should be located close to the oil filter. It will screw in like a spark plug. It has a harness plug. Easy to change, save yourself $70 in labor. You will need a fairly large wrench to remove
298 views
Usually answered in minutes!
×