Where is the crankshaft sensor located in a 1991 honda accord

if you feel savvy enough, check to see if it produces spark and also check if the fuel pump is working. If no spark usually a problem in the distributor. if no fuel coming out of the fuel line, maybe bad fuel pump. need to check if pump is not working.

yes honda accord on that year have problem whit distributor

ITS THE DISTR CAP..CLEAN THE 4 TIPS AND ROTOR WITH SAND PAPER..MY CAR DOES THAT ...

There is a sensor under the left hand side of the dash that would not allow it to start, provided that you have replaced the electronic spark module inside the distributor first, which is what it sounds like it would be, When you say you replaced the distributor I assume you replaced it complete!

cars wont start without fuel so it could always be A) fuel pump B) fuel filter C) fuel injecters dirty. any one of these will cause fuel not to reach your spark plugs and cause then eng not to start

Probably your crankshaft sensor

my jeep sounded similar-it ended up being crank timing senser-ran ok till she warmed up then the bucking bronco ride began-thats if she started-i too thought fuel -distributor but crank sensors my bet

replace the ignition stator, also known as the crankshaft position sensor.

camshaft sensor is in distributor(requires dist. replacement) crankshaft is behind lower timing belt cover

IDLE AIR CONTROL VALVE.....easy fix...controls idle fuel air mixture and if not working car will stall....