Where is oil filter located on the engine of a 2007 toyota aurion

So far all I've seen is a Technical Service Bulletin from Toyota describing the problem and repair procedure. Be careful with this it appears that many engines are blowing up due to oil loss. If I were You I would callYour Toyota dealer and talk to them, many times they will repair these as a matter of customer satisfaction. I hope this helps. Take care.

Mark, Complete instructions on how to oil and filter change link below.
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
DIY Oil Change pics 5 7L

how to change the oil on 2009 toyota tundra

Oil Filter Change Toyota Tundra 2007 2013 2007 Toyota Tundra 4 0L V6

The 2007 Tundra 5.7l engine doesn't have a spin on filter - it uses a replaceable paper cartridge within a permanent housing. Located under the skid plate on the front-left portion of the engine, the oil filter unit has two coolant hoses, a black plastic screw-in housing, and a large, metal, round screw with a 1/2" square fitting in the middle of it. The cartridge-type oil filter is in the housing.

I just had a non abs spindle put on my 06 corolla and my speedometer stop working and I have an abs light on now
so i am gonna try to put an abs spindle on and recconnect the abs sensor
hopefully that is the problem just an abs sensor connection

2007 Landcruiser 200 Petrol V8 How do you remove the engine oil filter and where is the sump drain?

One of (3) places. if you do not see a filter or filter housing underneath the car, it may be on top of the engine. if you still do not see on top of the engine, remove the plastic engine cover and find the oil filter housing. If all else fails, get a string flashlight and repeat all the steps...I sometimes find that I overlooked the filter because Toyota filters are "black" in color.

the 2007 avalon has a cannister oil filter loof under the passenger front of the car youl see the oil pan and drain plug its just in front of the oil pan towards the front of the car its metal casing with a small square in the center thats where youl need a 3/8 exstension and ratchet to loosin the cap to change the gasket for the cap when you get your oil filter it comes with a small plastic piece so you can drain the oil out of the oil filter case, to change the oil filter itself you need a toyota specific oil filter tool to loosin(can get at any toyota dealer run about 20 bucks) take the filter out change the gasket around the case and thats it hope this helps

Your filter is visable by looking under the car. its near the exhaust pipe again, but toward the front of the car. tucked near the plastic air shield.

the MAF sensor is between the air filter and throttle body. the idle controll is at the throttle body.  Its located on the throttle body on the left side. Follow the air intake to an intake manifold which sits on top of the throttle body. 

The 3.3 no longer has a "spin-on" filter. The filter is now a "cartridge-type", and is housed in a cricular aluminum housing under the engine.