My ignition wont turn back to off and wont start when tryed needs to be push started

Wriggle key around while pushing in before starting, then try starting, if it starts, replace ignition switch...

add a push start button its cheap and easy 2 wires one connected to positive post of battery 2 nd wire connected to starter place them on push start switch and thats that

remove your radio, there will be 2 bolts to undo, switch will slide into dash, unplug harness turn key to remove cable, if ignition wont turn you may have to take ignition apart to remove cable. reinstall in reverse procedure. will need to relearn new key to be able to start. try to start, leave key in run position, theft/security light will be blinking. leave on for 15 min or light stops blinking, turn off turn back to run without trying to start. leave on for another 15 min. turn off then start

Yes! You need to replace ignition , sounds like gear teeth got stripped .

Push in turn back all the way. You may have a lever u have to push or its not in gear all the way as in park.

Do the ignition lights go out when you try to turn it over? if so it sounds like a flat battery if not sounds like a starter motor problem, try a bump start - pushing it with a driver in it selecting second gear and lifting you foot of the clutch once pushed at speed

Starter motor needs replacing. The clicking is the sound of the solenoid pushing the drive gear of the starter out to the flywheel and it should start turning then. A faulty motor though wont turn so it either needs replacing or reconditioning.

sounds like security shut down which will start run for second then shut down after several time the security will shut down completely.......you can try what is called the relearn proceedure..this is what you dealer will do...might have to put battery charger on car first... then put key in ignition and turn to the run position do not crank leave it in the on position for ten minutes...... then turn key to the off position then back to the run position again for another ten minutes.....for the last time turn key off then back to run for the last ten minute cycle.... after the final ten minutes is up turn key to off position then attempt to start... let me know

Is the starter turning over the engine when it wont start or is nothing happening at all?
I might have your solution if I have more details.
If the engine is turning over but not starting then switch on the ignition and push it to start.If it starts you probably need a new ignition switch.

Please get back to me .Thanks

push on the spark plug and have someone start the ignition if that dont work its most likely your batery is dead