Is the brake rotor not bolted to the back of the hub. I've never known the whole assy needed changing? There are pictures on bing images showing the layout as several parts. Something in the hub locking mechanism isn't correctly assembled. Retrace your steps. Find a manual.
SOURCE: Nissan Frontier torsion bar replacement
well it depends how you want to adjust it, if you want to lower it, back out the screw on the torsion key a couple of turns. raise, screw it in a couple of turns
SOURCE: How to replace front rotors
You'll need to take the wheel bearings off. the rotors are bolted to the hub and the bolts are located in the back of the hub thus having to remove the wheel bearings and removed the hub/rotor assy.
SOURCE: where is the fuel filter 2005 nissan frontier?
Built in the gas tank. It is cleanable. Don't have to buy a new one.
It is built into the pump so if it would have to be replaced then you
would have to replace the whole pump. To me thats pretty crappy design.
Crawl under the truck, you should have two or three lines coming off the fuel tank, one will have the filter, one is the return, and one is emissions.
SOURCE: change brake light bulb on a 2000 Nissan Frontier
The entire bed line will need to be removed. The long screws that hold the metal bracet where the bed extender attaches also hold the tail light assembly in place.
I pulled the bed liner up at a 45 degree angle and layed it on top of the cab. This revealed the screws. Take both screws out and lay to the side along with the metal bracket for the bed extender.
Now firmly grab the edges of the tail light assembly and pull...there are 2 hard rubber nipples that snap in to hold the assembly. You will feel like you might break it but you won't..just pull straight back hard. The assembly will "POP" out and then you can just twist the back of each bulb there are (3) and pull out..now you will see the bulbs..just pull the bad bulb straight out and push the new one into place. Now just reassemble. Total time will be 30-45 min. for this repair.
SOURCE: what are the signs and symptoms of a fuel pump
You don't hear it running when your turn the key on just before the crank position.
You have replaced the fuel filter and it was pretty much stopped up. (destroyed pump trying to pump through stopped up filter.)
Because it was going bad you couldn't drive fast because it wasn't pumping enough fuel.
Disconnect fuel line and see if fuel comes out when you turn the key on.
Testimonial: "Thanks I will try the test! Appreciate the quick response"
129 views
Usually answered in minutes!
×