Code p0513 refers to incorrect immobiliser key===causes-- immobiliser system
As the engine starts after repeated tries it indicates that there is a problem in either the key fob(check battery/replace battery) or the immobiliser program in the CPU program
Try using a scanner tool to reset the CPU program
If that is not effective you may have to seek the services of a service dealer as the problem may be in getting the key reprogrammed to the vehicle or a new ECM
SOURCE: 93 Jeep Grand Cherokee Won't start
The crankshaft position sensor was seriously problematic in those old jeeps. It's located towards the top of the bell housing slightly to the driver's side I think.
That is a code for an invalid skim key. If you have another skim key try it. If it does the same thing then the skim module may be bad.
SOURCE: Can't locate air filter...
1.
Loosen clamp (1) and disconnect air duct at air cleaner cover (3).
2.
Pry over 4 spring clips (5) from housing cover (spring clips retain cover to housing).
3.
Release housing cover (3) from locating tabs on housing and remove cover (3).
4.
Remove air cleaner element (filter) from housing.
SOURCE: 2007 jeep commander rocky mountain no sound from radio
take it to the dealer. they will put a new radio in it if you have under 36000 miles
2,192 views
Usually answered in minutes!
×