Its a 350 small block,im not sure what you are asking
Well was needing to know is it a vortec I guess and is it compatible with a 350 out of a 85 caprice ?
×
SOURCE: need to know where the heater blower motor
Unless they moved it and are still using the same part,I would say that this one is located behind the glove box sandwitched between the underside of the dash and the top of the airbox.The blower motor is mounted to the underside of the airbox.
SOURCE: 2004 GMC Sierra Computer reset ??
I would suggest stopping by an AutoZOne or O'Reilly's and "borrow" their Scan Tool to erase any codes.
TO reset the "Change Oil" light, turn the ignition to ON (do NOT start the car). Press the accelerator pedal all the way down (then release) to the floor 3 times in less than 5 seconds. Change Oil light should flash then go off. If not, try it again. The trick is to get this done in 5 seconds ro less.
Testimonial: "One question answered correctly but the second question was misunderstood."
SOURCE: 1989 gmc sierra 6.2 liter diesel hard start when hot
hi, i have seen this problem ten years ago twice, but i was dumbfounded by the answer. all details aside, I replaced the ecm, and never had the problem again with both of them. this repair was a recommended repair by the local truck depot in my town, they stated the ecm got hot along with the truck and it lost the injector sensor signal. now, don't take this solution and run with it, i haven't repaired a 6.2 diesel in ten years and i maybe off track completely. but at least maybe you could ask around your town or maybe a large truck facility about this. of course, you should take to a shop to have diagnosed. hope i could help.
SOURCE: My fuel gauge on my 1993 GMC Sierra just went
There is a connection not connected ,or the fuel pump assembley is bad,either way the tank has to come off,or the bed has to be removed to access the problem,if this was at all helpful,please rate,thank you.
112 views
Usually answered in minutes!
×