SOURCE: 2001 ford taurus ABS will not light but brake light on
You have a bad ABS module. Had the same problem with my 2000 Taurus. The ABS module is a Bosch 5.3 You can have yours rebuilt for $170 or go to a junk yard and pull one from a 2000-2003 Taurus. Make sure its a traction control module if you have it on your car!
SOURCE: How do I reset the Check Engine Light on a 2005
only way to clear is with a scanner. The scanner will also give you the codes so it can be diagnosed. If its an emission issue your warrenty should cover it.
SOURCE: 2004 Sienna - VSC and TRAC OFF Lights are On
I have both lights on in my 2004 van also I have the engine light on. i took it to the dealer and they found the Yaw Rate Sensor (Vsc & TRAC) bad. The part is about$ 405 and is under the drivers seat. The other problems is the Catalyst System (engine light) about $1000 for parts.I have about 147,000 miles on my '04 and the problems started about 130,000.
SOURCE: I have a 2004 Pontiac Aztek. The ABS brake light
hello i have a similar problem with my 2002 aztek the ABS light comes on only after my ABS system kick on when it is not suppose to (like normal braking conditions) i took it to be looked at at my local shop who also said it was a front hub having a bad wheel speed censor less than a week after having the work done the problem returned i took it back and they ran diagnostics on it for somewhere around 5 hr and could find nothing so they replaces the hub again.... no shocker here the problem isnt fixed still most recent time i had it in the tech said the problem is the cars computer is "loosing the wheel" he showed me where the main wiring harness runs right next to the oil pan along the bottom of the engine. the wires that go to the ABS control for that side are very swollen and the wires inside are loosing contact. they told me that i would have to replace the harness or live with the problem. after doing research the harness is no longer made and cost around $900 just for the part then u have to pay for the labor of someone putting it in
Hope this sheds some light on your problem
Testimonial: "Thanx for the feedback. I was told that it might be an electrical short somewhere within the wiring harrness however I questioned that if that was the problem, would it not occur right away intead of weeks after the hub replacement. I finally took it to my own mechanic and her stated that her did find the connection clip between the hub and the wiring harress had a loose prong so he tighted it. So far so good and I haven't experiend the problem since, however I am waiting for wet weather since the problem seemed to occur during during or right after a rain. Again thank for your help. "
700 views
Usually answered in minutes!
×