Auto mode works, but selector function, defrost, heat,A/C does not, really hard to drive with inside of windshield iced up !
SOURCE: transmission flush - 2000 Honda Accord
cheaper than burning the trany trany oil is not change often dont make the mistake hope it help fixya our post thanks pierre
SOURCE: Honda accord auto trans sounds like gearbox hum when driving
Could be a wheel bearing,or possibly a differential bearing.
SOURCE: 2000 Honda Accord EGR Valve Error P0401
Jason,
-after you change the part you have to reset/clear the code
-this can be done by either:
(1) using the OBD2 code reader that Autozone used OR since option 2 (below) is very quick
(2) disconnecting the battery for about 30 seconds (this will delete
all codes/radio presets/etc) but it will also clear the 'check engine'
code
-this is what I do AFTER i write down my radio station presets :)
-hopefully the new EGR valve resolves your issue after you CLEAR the code
...but that code just means a an insufficient amount of Exhaust Gas
recirculation (pressure difference) used to keep the emissions in check
-if it comes back, then there are a few other fixes to try also
-let me know if you need further assistance
-please remember to rate me `fix-ya`if it works
thanks
SOURCE: Heater works but defrost fills inside with fog.
your heater core has probably sprung a leak.does the fog smell kinda sweet?....check the floor in the front where the floor mats are for moisture or even puddles of antifreeze.(the replacement of a heater core can be very expensive as the entire dash usually needs to be removed to access the heater core)also look under the engine near the firewall for antifreeze drips.
SOURCE: HVAC vent selector does not function. Air flow is
THe blend door seems to be stuck. When you change settings from defrost to floor air or, vent, the blend door opens and closes directing the air to the place you want it to go to. I have had some success spraying a lubricating oil such as WD40 under the dash on the blend door. You need to get under the dash with a flashlight to locate it. It looks like a flap. Spray it with a couple of shots of the WD40. Go easy on the spraying as you may be inhaling the fumes. Keep the doors and windows open to minimize the fumes. Wait about 1/2 hour and try the A/C functions. (defrost, floor, vent air)
345 views
Usually answered in minutes!
×