Where is the PCM located? - 2001 Ford Ranger Regular Cab

PCM

https://www.justanswer.com/mercury/4pxfd-cougar-how-replace-remove-pcm-1997-mercuery-cougar.html

ECU

https://www.cargurus.ca/Cars/Discussion-t7829_ds555855

https://www.google.com/search?q=1995+Mercury+Cougar+XR7+PCM+ECM+location

..

For every vehicle ever made that has a PCM!!

Google it

year make model PCM location

https://www.google.com/search?q=%E2%80%8Byear+make+model+PCM+location

..

• When one of these errors occurs, usually it will turn on the "checkengine" light on the dashboard. The PCM is one of potentially several on-board computers, or essentially the "brain" of theengine control system. The primary inputs to the PCM come from many sensors, of different types, that are spread around the car.

On the PCM are the connectors and all remote to it,. all sensors and actuators and power. (simple , all inputs and output to it)

USA, LHD, = :Left hand drive.

chapter 8D-5 in the OEM manual

XJ jeep, (chickodee) POWERTRAIN CONTROL MODULE (PCM)
The PCM was formerly referred to as the SBEC or
engine controller. On XJ models, the PCM is located
in the engine compartment next to the air cleaner
(Fig. 12).

5.3L Engine

The Powertrain Control Module (PCM) is located on the left front frame rail.

4.2L Engine

The Powertrain Control Module (PCM) is located in the engine compartment. It is mounted on the left side of the engine.

Ground points are in different locations throughout wiring harness. If you had any work done to engine it is very possible to have missed one of the grounding eyelets during the process of putting things together. Check along wiring harness in any area you can see or reach to try to locate any loose or disconnected ground looks.

On 1997 Chrysler Sebring 2.5L MFI 6cyl...
- the PCM is located in the left side of the engine compartment, beside the Power Distribution Center (PDC).



Fig. 1: Location of the PCM on the Cirrus, Stratus, Sebring convertible and Breeze models



Fig. 2: Location of the PCM on the Sebring coupe and Avenger models

- the Crankshaft Position Sensor is located: under hood, driver side, upper engine area, mounted on end of engine block



Fig. 4: Location of the crankshaft position sensor on 2.5L engines

Hope helps; remember to rating this answer and leave some testimonial comments.

PCM LOCATION FOR FOUR CYLINDER ENGINE IS LOCATED UNDER THE PASSENGER SIDE GLOVE BOX. PCM LOCATION FOR THE V6 ENGINE RIGHT CORNER OF THE ENGINE COMPAERMENT NEAR THE SHOCK TOWER.

You have to disengage the PCM (computer) wiring harness from the PCM as the PCM is removed from under the dash. The PCM connector is located on the firewall under the hood to the left of the brake booster, you'll see the a large retangular wiring connector (120 wires) with a single bolt in the middle. Unscrew the bolt, go back under the dash to remove the PCM.

The pcm is located on the drivers side in behind the fuse/relay panel against the fenderwell. You will have to remove the screws holding the fuse/relay panel, and move it out of the way to get to the pcm if you decide to remove it. Make sure to disconnect the negative cable from the battery first before you do any type of work. Also make sure to ground yourself to the van body before you handle it. Without doing this will damage the pcm, (static electricity). hope this will help you.