I have a hyundia matrix and the hazards are not working but the indiacators are. what could it be?

Hyundai Matrix - fuse box - engine compartment (gasoline) DescriptionAmpere rating [A]Protected components ALT120Generator B+40(A/CON, RR HTD, STOP, D/LOCK, HAZARD) Fuse ECU30Generator, Engine control relay, ECM RAD20Radiator fan relay IGN40Start relay, Ignition switch BLR40Blower relay P/WIN30Power window relay COND20Condenser fan relay #1 ABS30ABS control module, ABS bleeding connector ABS30ABS control module, ABS bleeding connector F/PUMP10Fuel pump relay INJ15Injector, lgnition coil SNSR10MAP sensor, Oxygen sensor, CP sensor, Knock sensor, Throttle position sensor ROOM LP10Audio, Room lamp, Overhead console lamp, lnstrument cluster DRL15DRL control module HORN10Horn relay A/CON10A/C relay FR FOG15Front fog lamp relay ECU10ECM, TCM LP20Tail lamp relay TAIL LH10Left rear combi lamp, Left position lamp, Left License lamp TAIL RH10Right rear combi lamp, Right position lamp, Right License lamp H/LP LH15Left head lamp H/LP RH15Right head lamp, (H/LP IND) Fuse Engine compartment (diesel) Hyundai Matrix - wiring diagram - fuse box diagram - engine compartment (diesel) DescriptionAmpere rating [A]Protected components FUSEALT100Generator B+40(A/CON, RR HTD, STOP, D/LOCK, HAZARD) Fuse, Deicer ECU30Generator, Engine control relay, ECM RAD20Radiator fan relay IGN40Start relay, Ignition switch BLR40Blower relay P/WIN30Power window relay COND20Condenser fan relay #1 ABS30ABS control module, ABS bleeding connector ABS30ABS control module, ABS bleeding connector F/PUMP10Fuel pump relay ECU30ECM No.5 (Batt+) ECU10ECM No.4 (Batt+), Stop lamp switch, PTC heater relay #1 SNSR10Glow plug relay, Assistor heater relay 1/2, Stop lamp switch, TDC sensor, EGR act, Throttle plate act, VGT vacuum ROOM LP10Audio, Room lamp, Overhead console lamp, lnstrument cluster, ETACS, Luggage lamp DRL15DRL control module HORN10Horn relay A/CON10A/C relay FR FOG15Front fog lamp relay ECU10ECM, TCM LP20Tail lamp relay TAIL LH10Left rear combi lamp, Left position lamp, Left License lamp TAIL RH10Right rear combi lamp, Right position lamp, Right License lamp H/LP LH15Left head lamp H/LP RH15Right head lamp, (H/LP IND) Fuse FUSIBLE LINKPTC HTR 140PTC heater relay #1 GLOW80GLOW relay PTC HTR 240PTC heater relay #2 FFHS30FFHS relay PTC HTR 340PTC heater relay #3 Inner Panel Hyundai Matrix - fuse box - inner panel DescriptionAmpere rating [A]Protected components H/LP IND10Head lamp indicator HTD IND10Defogger relay, Left(Right) outside mirror motor, Rear window motor A/CON10A/C Switch RR HTD30Defogger relay STOP10Stop lamp switch, Power window relay D/LOCK15Door lock(unlock) relay, ETACM, Sunroof relay HAZARD10Burglar alarm relay, Hazard relay AUDIO10Audio C/LIGHT15Cigarette lighter A/B10SRS control module A/B IND10SRS IND. T/SIG10Hazard switch, Seat belt timer, Instrument cluster, ABS control module, Pre-excitation resistor, Washer motor ECU15ECM, Vehicle speed sensor, TCM, Ignition coil ETACS10ETACM, A/T Shift lever RR WPR10Rear wiper motor, Rear wiper relay START10Start relay FRT WPR20Wiper relay, Washer motor, Wiper & Defogger timer S/HTD15Left (Right) front seat warmer switch P/OUTLET25Front (Rear) power outlet IG210ETACM, Power window relay, Defogger relay, Sunroof relay Head lamp relay, Blower relay O/S MRR10Outside mirror switch, Rear fog lamp relay

That means your ABS system has a problem and needs to be fixed. It could be anything from a wire to sensors. Best to have a suitable mechanic look at it.

u need to re-programme the immobilier chip. u cant buy pass it.
some locksmiths do it .

Hi, Acording to autodata the following applies.
hyundia matrix 1.6 01-09 engine g4ed
stage 1 +30nm
stage 2 +90 degrees
stage 3 slacken 360 degrees
stage 4 +30nm
stage 5 +90 degrees

Jon

go to www.fitness.manualsonline.com or www. retrevo.com if you want service manual go to www.repairmanualdownloads.com

God bless you

bad contact between one of the ABS wheel sensor, you need to identify which and replace

It is very difficult and requires special tools and skills, you will also need to have the front end aligned after the part change.

If the car is under warranty (3 years/36,000 miles I think) have the dealer check it. You might have a blown fuse, and most owners manuals show the location and amperage of the fuses for the various systems. Generally speaking, a fuse should not blow unless something is overloading that circuit, so you might have something like water ingress shorting wiring or a heater fan motor drawing too many amps...start with the fuse.

you need to get a manual for your engine , i dont know what one you have, it has to be done by a professional , because if not right when you go to start it could do major damage to your engine.

hi , it sounds more like the flasher box is stuck not the relay, and wd40 wont to it any good lol..better off replacing it proberbly cheaper than a can of wd40 lol...hope that helps