Changed head lights they come on some time if I move my turn signal now they don't work my high beams come on when I pull back on turn signal they do not work if I push forward to turn on ?
Re: 1994 Ford ranger why would head lights not work
Common problem.
T/S lever is part of the "multifunction switch" that controls hi/lo lamps. It can be replaced by removing the lower shroud (3 or 4
screws from the bottom up). SW1093 @ Auto Zone about $66.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Diane, There are 2 separate flashers on your vehicle, one is for the emergency/4 way lights and one flasher is for the signal lights. It may be worth the couple bucks and replacing the signal flasher as a first step. Recheck bulbs/sockets, fuses/relays, flasher. If all looks good possible signal switch is bad. Remove switch and try to clean contacts or replace switch. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info." https://ca.answers.yahoo.com/question/index?qid=20090405174036AARb2Uc 1994 Ford Ranger Turn Signal Electrical Problem 1994 Ford Ranger 93 Ranger Turn Signal Problem Ford Truck Enthusiasts Forums
? 3:23 www.youtube.com/watch?v=I2SUGIvYAWc Jul 12, 2013 - Uploaded by Raybob216
My 04 exployer left turn signal and break light not working fix loose wires behind ... bulb and come to find out wire had popped out of the harness. ... How to Change Ford Explorer 2002 Flasher Relay for Hyper Flasher Relay ... How To Install Replace Turn Signal Wiper High Beam Switch Ford Ranger 95-98 ...
ok, first ,, check all the bulbs again, and *** make sure that your hands never touch the actual bulb, these lights will turn the oils from your hands into cooking grease when it comes to these bulbs and cause them to blow out much to early on in their life span, , next,, Pull the light switch ( high beam switch towards you for a quick flash of the head light high beams,, if this doesn't make the high beams come on, your problem is going to be in the switch itself ( what your calling the high beam/turn signal lever) before going to that extreme though,, if you have a junk yard near you, go pull one of the relays off a junked vehicle, and stab it into your system one at a time, it could be something as simple as a relay heating up and disconnecting prematurely due to heat ,, if you don't have a junk yard that you can grab a relay,, here is a link that shows how to check them, But its time consuming http://www.youtube.com/watch?v=C8t25GjZ6i4&NR=1
if you are sure the high beams are not defective you will need to replace the high beam switch on the steering column which is part of the turn signal and wiper switch.
×