How can I down load the user manual for a 1993 Plymouth grand voyager SE?

SOURCE: repair manual for 1993 plymouth voyager, ignition replacement

Go to autozone's website at autozone.com and register your vehicle. It's free, handy, and you will have access to a full online repair manual for your particular vehicle. Hope this helped, and good fixin'.

SOURCE: Need to remove the alternator

Remove windshield wiper blades (mark the arm and stud to put back exact). The next two steps you might have to lower/raise the hood. Remove cover just below the windshield(each end has a phillips screw turn 90 degrees so arrow points toward center of van). Remove the 4 metal braces. Remove windshield wiper motor/linkage assembly(the whole tray comes out). Remove drive belt. Disconnect negative side of the battery. Remove alternator horizontal mounting bracket. Loosen vertical bracket bolts to get to electrical connectors. Finish removing bolts and alternator.

SOURCE: Needed serpentine belt diagram for a 91 ply. voyager 3.3L engine

Here's a link to the diagram you need...

http://www.gates.com/common/part_locator/view_diagram.cfm?id=S7006

Good luck and please rate this solution. Thanks.

Testimonial: "Looks good."

SOURCE: 1996 Plymouth grand voyager se-need diagram

The BCM is located on the drivers side under the the steering column. It is behind the fuses and to get to it you have to remove the bash board plastic, than a pice of metal and than you have to remove the fuses box. It will take you approximately 20 min to remove everything. Once you remove the BCM you need to take note of the Part Number P/N. It has to be the same P/N on the replacement BCM. You can use any BCM from years 1996-2000 but make sure the electrical configuration is the same as yours (Power windows, alarms, etc.). I bought my BCM on the junk yard for 35 dollars and my car works perfectly.
I hope this may have assisted you,
Tom

Mike Butler

• 6674 Answers
• Posted on May 27, 2010

SOURCE: 1999 Plymouth Voyager engine compartment fuse/realy diagram

I have to assume you have lost the cover for it, as the schematic/Map, is on the underside of it.