How do i change power steering belt on 1995 park ave ultra

I am not sure about changing the name as my 2000 park ave. only indicates driver one or driver two. To reset the memory for seat/ mirror position is rather simple: with the ignition on and the car in park, adjust your seat and mirrors to the desired position. Then press and hold the desired button (driver one or two) until you hear a beep, This is the procedure that works on my 2000 park ave. I hope this helps you.

check to make sure the rear brake shoes are adjusted before adjusting park brake cable. pull the brake drum off and inspect brake shoes before adjusting

over tension and old age

sounds like power steering pump is going out or low on fluid

I can help, a belt diagram for a 1997 park ave, some of these cars come with a super charger, heres a diagram that list both the regular belt and then the charger belt, use what is needed, hope this helps.

The power steering pump cap is on the passanger side of the engine and between the engine and back fire wall. It is a very tight fit to get the cap off and back on.

Make sure the battery cables are clean and tight on the battery. Check to see if the wires to the starter are tight. Try starting it in neutral to make sure the safety switch is being make. Also hold it up into park and try.

if you buy your belt from Autozone the belt routing is on each package

have you checked the coil packs

I think any dealer would have these on hand; if my memory is working right, these did have to be a specific class and will need to be torqued carefully to avoid stripping the female threads.