Question about Cars & Trucks

1 Answer

Why does my transmission stops pulling but starts back pulling after sitting for a few minutes.

Thinking of replacing the filter first.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 5,316 Answers

Good place to start--replace clogged filter.

Posted on Dec 18, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

94 Dodge Ram 3500 Van runs fine, but will not move much. Previously would start in Park, now will only start in Neutral. After sitting for a few hours or a day it will run a few hundred yards but then...


Dumb question but, did you check the trans fluid? A torque converter can hold 6 quarts of fluid or more and if the van has sat for an extended period of time the fluid drains from the converter and will come out of the vent tube causing a no movement issue

Oct 21, 2013 | 1994 Dodge Ram 3500

1 Answer

Transmission goes out when stopped and comes back on when car is restarted


Any transmission issue is usually the beginning of the end but you should check the fluid level if the fluid is any color other than red see if it smells burnt. next drain and remove the transmission pan if there are a lot of shavings and pieces of any kind you most likely need it rebuilt or replaced. If not then the filter may be plugged you should try changing the fluid and filter. If it is bad a good used transmission cost between $600 and $900. It costs between $1500 and $2000 to have yours rebuilt.

Mar 24, 2013 | 2001 Chevrolet Monte Carlo

1 Answer

Driving down the road and tranny started slipping so I pulled to the side of the road, then let the truck sit for 10 minutes, then the tranny worked again but within 1500 feet was slipping again, and will...


It sounds like you either have a dirty filter, or a solenoid is faulty in the transmission. Change the fluid and filter, put some Lucas transmission oil in it and see if that resolves the issue. If the solenoid is dirty then it will cause the transmission to shift improperly, the Lucas will clean it.

Apr 08, 2011 | Chevrolet Avalanche Cars & Trucks

1 Answer

Just began having starting trouble...


if no codes check fuel pressure possible fuel filter clogging-or fuel pump on way out also-check-clean egr valve possible carbon build up

May 05, 2010 | 2001 Chevrolet Silverado 2500HD

1 Answer

Got a 99 jeep grand cherokee larado. when you first get in and take off the automatic does great until you go thru a few shift cycles then it shifts hard into 3rd. you can stop and turn off the jeep and...


Dirty transmission filter.
Most "service" places only pump out the fluid through the dipstick tube and tell you that the filter will be OK. That way they don't get an ATF bath when they pull the pan.
I'm guessing that the crud in your tranny is pluging the filter after a few miles, when you shut it off, the fluid runs back down, washing the dirt and metal pieces back into the pan.

Sep 04, 2009 | 1999 Jeep Grand Cherokee

2 Answers

Goes to 4000 rpms to 5500 rpms before changing from 1st to 2nd g


Ford : back the truck up 10ft put truck in neutral and disengage four wheel low. (You can't drive in four wheel low cause its a pulling gear and you won't do over 3-5 mph.)
Nissan: start truck see if it idles normal. If so rev motor and check throttle for sticking and check EGR valve make sure its not stuck open or malfunctioning when you drive it..

May 24, 2009 | 1992 Nissan Pickup

1 Answer

2001 jeep grand cherokee transmission


The problem sounds like a bad governor solenoid. I would replace it. You will have to drop the bottom pan and it is held on by 2 bolts.

Mar 22, 2009 | 2001 Jeep Grand Cherokee

1 Answer

1999 jeep grand cherokee transmission


This is called limp mode chrysler did this to protect the transmission without leaving the owner stranded by the road,a few things will cause this mainly putting the wrong fluid in the transmission,they use only atf+4,or the govenor pressure sensor is acting up which should cause a check engine light to come on,or the transmission just needs a fluid and filter change,should be done every 2yrs or 36k miles,due the fluid and filter change about 40.00 but if you have the wrong fluid then the whole system needs to be flushed and refilled-transmission-torque convertor,radiator and cooler if equipped and all lines.

Mar 09, 2009 | 1999 Jeep Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...