Question about 1991 Dodge Stealth

Open Question

How do I remove the tripometer reset button from a 1991 dodge stealth speedometer

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: Speedometer and Tachometer

common problem on caravans bad solder joints on circuit board of instrument cluster.(known problem dodge refuses to acknowledge) remove cluster from dash use a cheap $12.00 Low Power soldering iron from radio shack and reheat solder joints on cluster. can be very hard to notice broken solder joints to the untrained eye. trust me on 90% of all weird electrical problems this model is known for this cures it. not bcm or ecm modules like some mechanics would have you believe.

Posted on Aug 14, 2008

Ad
  • 1 Answer

SOURCE: 1991 dodge stealth with auto trans will not go

i knew my 95 stealth overdrive was going bad i was driving in overdrive and the engine would rev up for a second hardly noticeable surging and it just stoped pulling i turned the button off and it will do fine in drive bottom line the piston seal in overdrive drum is bad rebuild it

Posted on May 11, 2009

  • 49 Answers

SOURCE: how much trans fluid capacity in the manual 5 speed dodge stealth

never change filter as i dont think it exsists. The fill should be located on the transmission up from the drain. You fill untill fluid pours out and stops then replace plug. Car must be level.

Posted on Apr 19, 2010

maygemini
  • 147 Answers

SOURCE: on a 1991 dodge stealth 3.0 5 speed manual what is

GL4 or 75-90 weight gear oil....I use to use almost 3 quarts.. just keep filling inthe fill hole until it comes out and then force more in and put the bolt on it... better to slightly overfill gear oil boxes they do not foam like hydraulic fluid...Plus that Manual getrag tranny is discontinued when those aluminun housed trannys blow the case cracks... you will be onthe National PArts locater trying to find one they costs 500-800 bucks froma junkyard!!!!

Posted on Jun 17, 2010

  • 2 Answers

SOURCE: will not turn over will not start

did u find the problem i have the same thing goin on with mine

Posted on Aug 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Speedometer don`t work


i found a "trick" with my van, same one as yours. mine did the same thing, i thought i had to replace the instrument panel. a very simple fix alot of people dont know about. just push and hold your odometer/tripometer reset button on your dash board (the black button thats sticks out under your speedometer) for about ten seconds or so, while your car is comepltly shut off, no keys needed, where your milage normally reads it will say "softe4" or something very similar,its going into their builtin software mode, release the button and watch your dash do some crazy stuff, dont get nervous, like i did, i thought i really messed it up, all your gauges go wild.. it resets everything to exactly where it belongs, recalibrates it if you will.. dodge did a good thing putting this feature in, avoids costly, unneccessary repairs. give it a try, hope it helps.

Feb 03, 2013 | 2002 Dodge Grand Caravan

1 Answer

I have a 1991 dodge stealth dohc and removed th cas sensor with out marking the old one what is the proper way to install the new one.


Marking does not matter that much because you always need to reset the timing anyway.

Here is a link for crank and cam position sensor replacement:
http://www.stealth316.com/2-cas-91-92.htm

And here is one for timing:
http://www.stealth316.com/2-ignition-timing.htm
It is just like any distributor timing except that you have to ground the right test connector, otherwise the ECU will vary the timing based on things like temperature, knock, fuel, etc.

Aug 08, 2010 | 1991 Dodge Stealth

1 Answer

My 1991 Dodge stealth is overheating. I have a new radiator and thermostat installed.. No fluid is leaking and my fans are working. It typicaly runs hot when im sitting still or start traveling long...


Hello Guest and thank you for asking your question, on Fixya.

Here is a simple process that will walk you through a few steps that will pinpoint the overheating problem on your 1991 Dodge Stealth, without even using any tools. It has helped millions of people, and I am certain that it will help you, because I wrote it for people like you. So here is the link:
How to diagnose your overheating 1991 Dodge Stealth

Get more great, money saving, tips and tricks about your vehicle from: twitter.com/acoates23234

Thanks for the vote, and good luck!

Jul 13, 2010 | 1991 Dodge Stealth

1 Answer

Timing belt replace on 1991 dodge stealth 3.0 24valve non turbo diagram


My apologies for the delayed response. I am going back and answering questions that were never answered.
Click on the following Link. It has all the Diagrams for the Timing Belt you will need.
Before Clicking, let me know if this helped.
Again my sincerest apologies,,..

http://www.2carpros.com/car_repair_information/year/1991/make/dodge/model/stealth/1991_dodge_stealth_timing_belt_diagram_marks.htm

Jan 12, 2010 | 1991 Dodge Stealth

2 Answers

1991 crysler lebaron odometer not working speedometer is o.k.


Check the vehicle speed sensor in the transmission.

May 16, 2009 | 1991 Chrysler LeBaron

1 Answer

1991 dodge stealth with auto trans will not go into overdrive light on the dash cluster is working


i knew my 95 stealth overdrive was going bad i was driving in overdrive and the engine would rev up for a second hardly noticeable surging and it just stoped pulling i turned the button off and it will do fine in drive bottom line the piston seal in overdrive drum is bad rebuild it

Mar 06, 2009 | 1992 Dodge Stealth

3 Answers

1991 dodge stealth problem


it could be your fuel pump , even if the pump kicks in, it has to pump approx 40 pounds of pressure to the fuel rail

Nov 06, 2008 | 1992 Dodge Stealth

2 Answers

Speedometer and Tachometer


It could have a short behind the dash where you pushed the tripometer. Check all your fuses and you will find one for your gauges thats bad replace if and see if it works, Hope so Take care

Jun 17, 2008 | 2001 Dodge Grand Caravan

Not finding what you are looking for?
1991 Dodge Stealth Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...