Question about 1997 Jeep Grand Cherokee

1 Answer

The air con on my 1997 jeep grand cherokee 4 lt increases engine vibration sound

Tried nothing yet

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 20,706 Answers

Is the engine misfiring
or the compressor just shaking
this is obvious if you just look.
if not, get it serviced, we can go beyond that.
we use a stethoscope to listen to both , and hear what is making noise. or just look.

Posted on Dec 15, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
fastboyz
  • 674 Answers

SOURCE: Airbag light indicator: Jeep Grand Cherokee 1997

there are many sensors and and each airbag have sensors so you will have to get it scanned to know where to start. just a note air bag parts can be very expensive so check out your local salvage yard. they can save you hundreds. good luck
paul

Posted on Sep 28, 2008

Mikey108
  • 475 Answers

SOURCE: 2002 Jeep Grand Cherokee Lardo misfiring

You say you changed the cam sensor. A1391 code is a crank sensor on the top of the trans. bell housing.

Posted on Feb 24, 2009

cbgarner
  • 138 Answers

SOURCE: Headliner falling in my 1997 Jeep Grand Cherokee with center console thing

You can try to use the spray contact adhesive

Posted on May 13, 2009

  • 10 Answers

SOURCE: location of crankshaft position sensor Jeep grand cherokee 1997

left rear of engine block,on transmission bell housing.best way from top under brake booster use a wrench,

Posted on Jun 13, 2009

  • 58 Answers

SOURCE: replace fuel filter on 1997 jeep grand cherokee

If you have the V8 engine, the filter is actually part of the fuel pump. WHICH IS IN THE TANK

Posted on Jun 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to eliminate vibration sound when air con is turned on on my 1997 jeep grand cherokee 4 lt


It sounds as if you either have some debris in your blower fan or have some broken fan blades. You need to remove the blower motor and inspect the fan, clean any debris that is in the blower housing and replace any broken or worn parts.

Dec 14, 2014 | Jeep Cars & Trucks

1 Answer

2002 Jeep Grand Cherokee Limited P0846 code



Trouble Code: P0846

A/T 2/4 Pressure Switch Circuit Malfunction
Possible Causes:


2/4 pressure is incorrect, or internal transmission faults exist 2/4 pressure switch circuit is open, shorted to ground or power 2/4 pressure switch is damaged or it has failed TCM relay power circuit to L/R switch is open (loss of B+) PCM/TCM has failed

May 16, 2012 | 2000 Jeep Grand Cherokee

1 Answer

Can a 98 jeep grand cherokee 4.0l perminant 4+4 run without the front propshaft


The front propshaft on my full time 4 wheel drive 94 Grand Cherokee was vibrating badly years ago so I removed it and my Jeep has driven just fine without it since, no vibrations.Doesn't seem to cause any harm that I know of.

Feb 05, 2011 | 1997 Jeep Grand Cherokee

1 Answer

Back speakers can't handle bass


you need to replace all the speakers in the truck except the front tweeters if you have them. I replaced all four with new infinitys from futureshop. Installed it was near 500 dollars. You need to get 2 ohm to match the infinity deck if yours is infinity. Most other systems are 4 ohm, these are 2 x 2 ohms for 2 and 4 ohm use. the factory's are garbage and use paper cones. The rears have plastic caps holding the tweeters in. On all four the paper was ripped away from the magnet and it caused them to vibrate and shake, once replaced with 180 watt infinitys...great sound.

Jul 06, 2010 | 1997 Jeep Grand Cherokee

1 Answer

Air con stuck on, temp gets very hot


have you looked at the switch,
try this first then check power to air con pump

Mar 02, 2010 | 1999 Jeep Grand Cherokee

1 Answer

2.7 crd.grand cherokee 2002. Varying idling speed,dimmng lights


well it could be the idle control valve or vacuum leak check all vacuum lines for cracks and listen for air sound you may need to check PVC valve

Feb 08, 2010 | 2002 Jeep Grand Cherokee

1 Answer

It makes a noise while moveing likea roar


If the car makes the sound you say,try this.Turn the air/con off and on and see if the sound goes off and on.The car has an electric fan that comes on with the air/con to help cooling of the motor.It may also be the fans for the engine cooling system.If the car starts without the sound and it then kicks in later,its the cooling system working properly.Hope this helps

Oct 30, 2009 | 1997 Jeep Grand Cherokee

1 Answer

1997 Jeep Grand Cherokee Stalls when put in gear V8


Replace the throttle postioning sensor, and mass air flow sensor

Mar 09, 2009 | 1997 Jeep Grand Cherokee

Not finding what you are looking for?
1997 Jeep Grand Cherokee Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...