Question about Cars & Trucks

1 Answer

This is an elect start, battery fulluy charged. but will not sdtart

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 11,748 Answers

What vehicle ?

Posted on Dec 14, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

99 suzuki vitara v6 turns on all power but wont

the starter uses 10x more elect. power than the head lamps
or 100x more than dash lamps. it means little.
what matters most is jumper cable starts.
does it crank with jumper cables to a running, donor car,(aaa jump)
no bad starter
no, bad starter key line( immobliizer or such) ask how to test.
yes, cranks great, now.
that means the battery was dead,
i charge the battery and it now cranks, due to lights left on or
charge system failure, if battery goes to 13.3 to 15v running good
if on the charge system failed. (causing battery discharge)
if after charging a battery it will not crank car, its a bad battery (jumps ok)

Sep 09, 2014 | 1999 Suzuki Vitara

1 Answer

Started car turned on heat and car died

clean battery lugs.
#1 reason for power loss (elect)
#2 bad battery. or just dis-charged, , charge it up to 12.6v,

Dec 07, 2013 | 1999 Toyota Camry

2 Answers

Battery not charging, replaced but still no good

check condition of belt. If a "v" belt the back of the belt must be level with the top of the pulley otherwise the belt slips under load and it take power to drive an alternator while charging check belt tension and adjust if necessary. If a serpintine belt-multigroove make sure the belt is properly tensioned

Jan 23, 2013 | 2004 Toyota Camry

1 Answer

1984 pace arrow 454 chevy, just quit no engine,lights etc. batterys show charge, no elect

The engine and chassis circuits are not directly connected to the coach.
If the engine battery shows that it is charged, you would check the circuit from the battery to the starter and to the fuse box. Be sure and check the ground connections too. Could be a faulty wiring connection or a fuseable link.

Oct 04, 2012 | 1989 Cadillac Fleetwood

1 Answer

I the battery is charged and all the elect is working and I go to start the engine and I only hear on click from the engine is it the starter

You hear clicks and the car doesn't start? That means that you have battery but not enough for the car to start. The battery might be faulty and in need of replacement. I've got a 2000 Cirrus Lx V6, the same happened to me the reason? No water in one of the battery's slots.

Apr 02, 2011 | 2005 Dodge Ram 1500

1 Answer

Are accord will run fine then start losing elect. power. Unitl the car wont produce enough current to fire. We replaced the batterty and the altinator and still have the problem.

Charge the battery and put a voltmeter on it. While running the volmeter should read 14.6 volt or at least in that vicinity. Battery volts before you start it should be at 12.6 or close. When alternator is charging correctly, it should produce 2 volts higher. Hopefully this will let you know if you have good parts and then go from there.

Jan 17, 2010 | 1992 Honda Accord

1 Answer

I have in 02 when i sdtart my Vento from 1995

sounds like a blown fuse try replacing the fuses

Aug 28, 2009 | 1994 Volkswagen Jetta

1 Answer

Electical power only to starting and charging systems, none to any thing else?

i would suggest that u start to check power from 85A main fuse it supplies the power to all those circuits! circuit must be open!

Apr 19, 2009 | 1992 Toyota Corolla

4 Answers

2005 Ford ranger sdtarting issues

Bad inertia switch, I just had the same problem.

Sep 17, 2008 | 1991 Ford Ranger Supercab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides